- 您现在的位置：买卖IC网 > PDF目录12015 > ADUC834BSZ (Analog Devices Inc)IC ADC DUAL16/24BIT W/MCU 52MQFP PDF资料下载
参数资料
| 型号： | ADUC834BSZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 24/80页 |
| 文件大小： | 0K |
| 描述： | IC ADC DUAL16/24BIT W/MCU 52MQFP |
| 产品培训模块： | Process Control |
| 标准包装： | 1 |
| 系列： | MicroConverter® ADuC8xx |
| 核心处理器： | 8052 |
| 芯体尺寸： | 8-位 |
| 速度： | 12.58MHz |
| 连通性： | EBI/EMI，I²C，SPI，UART/USART |
| 外围设备： | POR，PSM，PWM，温度传感器，WDT |
| 输入/输出数： | 34 |
| 程序存储器容量： | 62KB（62K x 8） |
| 程序存储器类型： | 闪存 |
| EEPROM 大小： | 4K x 8 |
| RAM 容量： | 2.25K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.7 V ~ 5.25 V |
| 数据转换器： | A/D 3x16b，4x24b; D/A 1x12b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 52-QFP |
| 包装： | 托盘 |
| 产品目录页面： | 738 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页
REV. A
–30–
ADuC834
Flash/EE Program Memory
The ADuC834 contains a 64 Kbyte array of Flash/EE program
memory. The lower 62 Kbytes of this program memory is avail-
able to the user, and can be used for program storage or indeed
as additional NV data memory.
The upper 2 Kbytes of this Flash/EE program memory array
contain permanently embedded firmware, allowing in circuit serial
download, serial debug and nonintrusive single pin emulation.
These 2 Kbytes of embedded firmware also contain a power-on
configuration routine that downloads factory calibrated coeffi-
cients to the various calibrated peripherals (ADC, temperature
sensor, current sources, bandgap references and so on).
This 2 Kbyte embedded firmware is hidden from user code.
Attempts to read this space will read 0s, i.e., the embedded firmware
appears as NOP instructions to user code.
In normal operating mode (power up default) the 62 Kbytes of
user Flash/EE program memory appear as a single block. This
block is used to store the user code as shown in Figure 17.
FFFFH
0000H
F800H
F7FFH
USER PROGRAM MEMORY
62 KBYTES OF FLASH/EE PROGRAM MEMORY IS
AVAILABLE TO THE USER. ALL OF THIS SPACE CAN
BE PROGRAMMED FROM THE PERMANENTLY
EMBEDDED DOWNLOAD/DEBUG KERNEL OR IN
PARALLEL PROGRAMMING MODE.
EMBEDDED DOWNLOAD/DEBUG KERNEL
PERMANENTLY EMBEDDED FIRMWARE ALLOWS CODE
TO BE DOWNLOADED TO ANY OF THE 62 KBYTES OF
ON-CHIP PROGRAM MEMORY. THE KERNEL PROGRAM
APPEARS AS ‘NOP’ INSTRUCTIONS TO USER CODE.
62 KBYTE
2 KBYTE
Figure 17. Flash/EE Program Memory Map in
Normal Mode
In Normal Mode, the 62 Kbytes of Flash/EE program memory
can be programmed programmed in two ways, namely:
(1) Serial Downloading (In-Circuit Programming)
The ADuC834 facilitates code download via the standard UART
serial port. The ADuC834 will enter Serial Download mode
after a reset or power cycle if the
PSEN pin is pulled low through
an external 1 k
resistor. Once in serial download mode, the
hidden embedded download kernel will execute. This allows the
user to download code to the full 62 Kbytes of Flash/EE program
memory while the device is in circuit in its target application
hardware.
A PC serial download executable is provided as part of the
ADuC834 QuickStart development system. Appliction Note
uC004 fully describes the serial download protocol that is used
by the embedded download kernel. This Appliction Note is
available at www.analog.com/microconverter.
(2) Parallel Programming
The parallel programming mode is fully compatible with conven-
tional third party Flash or EEPROM device programmers. A block
diagram of the external pin configuration required to support parallel
programming is shown in Figure 18. In this mode, Ports 0, and 2
operate as the external address bus interface, P3 operates as the
external data bus interface and P1.0 operates as the Write Enable
strobe. Port 1.1, P1.2, P1.3, and P1.4 are used as a general
configuration port that configures the device for various program
and erase operations during parallel programming.
Table XIII. Flash/EE Memory Parallel Programming Modes
Port 1 Pins
P1.4
P1.3
P1.2
P1.1
Programming Mode
0000
Erase Flash/EE Program,
Data, and Security Modes
1001
Read Device Signature/ID
1010
Program Code Byte
0010
Program Data Byte
1011
Read Code Byte
0011
Read Data Byte
1100
Program Security Modes
1101
Read/Verify Security Modes
All other codes
Redundant
VDD
GND
P1.1 -> P1.4
PSEN
RESET
P3
P0
P2
ADuC834
5V
PROGRAM MODE
(SEE TABLE XIII)
GND
PROGRAM
DATA
(D0–D7)
PROGRAM
ADDRESS
(A0–A13)
(P2.0 = A0)
(P1.7 = A13)
COMMAND
ENABLE
P1.0
EA
ENTRY
SEQUENCE
VDD
GND
P1.5 -> P1.7
TIMING
Figure 18. Flash/EE Memory Parallel Programming
User Download Mode (ULOAD)
In Figure 17 we can see that it was possible to use the 62 Kbytes
of Flash/EE program memory available to the user as one single
block of memory. In this mode all of the Flash/EE memory is
read only to user code.
However, the Flash/EE program memory can also be written to
during runtime simply by entering ULOAD mode. In ULOAD
mode, the lower 56 Kbytes of program memory can be erased
and reprogrammed by user software as shown in Figure 19.
ULOAD mode can be used to upgrade your code in the field via
any user defined download protocol. Configuring the SPI port on
the ADuC834 as a slave, it is possible to completely reprogram
the 56 Kbytes of Flash/EE program memory in only 5 seconds.
See Application Note uC007.
相关PDF资料 |
PDF描述 |
|---|---|
| VI-JVP-IY-F2 | CONVERTER MOD DC/DC 13.8V 50W |
| VE-B3D-IY-F2 | CONVERTER MOD DC/DC 85V 50W |
| AT91SAM9XE256-QU | MCU ARM9 256K FLASH 208-PQFP |
| VI-JVN-IY-F4 | CONVERTER MOD DC/DC 18.5V 50W |
| VI-JVM-IY-F2 | CONVERTER MOD DC/DC 10V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADUC836 | 制造商:AD 制造商全称:Analog Devices 功能描述:MicroConverter, Dual 16-Bit-ADCs with Embedded 62 kB Flash MCU |
| ADUC836_02 | 制造商:AD 制造商全称:Analog Devices 功能描述:MicroConverter, Dual 16-Bit ADCs with Embedded 62 kB Flash MCU |
| ADUC836BCP | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| ADUC836BCPZ | 功能描述:IC MCU 62K FLASH ADC/DAC 56LFCSP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 标准包装:38 系列:Encore!® XP® 核心处理器:eZ8 芯体尺寸:8-位 速度:5MHz 连通性:IrDA，UART/USART 外围设备:欠压检测/复位，LED，POR，PWM，WDT 输入/输出数:16 程序存储器容量:4KB（4K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:1K x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 3.6 V 数据转换器:- 振荡器型:内部 工作温度:-40°C ~ 105°C 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 包装:管件 其它名称:269-4116Z8F0413SH005EG-ND |
| ADUC836BCPZ-REEL | 功能描述:IC MCU 62K FLASH ADC/DAC 56LFCSP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 标准包装:38 系列:Encore!® XP® 核心处理器:eZ8 芯体尺寸:8-位 速度:5MHz 连通性:IrDA，UART/USART 外围设备:欠压检测/复位，LED，POR，PWM，WDT 输入/输出数:16 程序存储器容量:4KB（4K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:1K x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 3.6 V 数据转换器:- 振荡器型:内部 工作温度:-40°C ~ 105°C 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 包装:管件 其它名称:269-4116Z8F0413SH005EG-ND |
发布紧急采购，3分钟左右您将得到回复。