参数资料
型号: SX1211I084TRT
厂商: Semtech
文件页数: 16/92页
文件大小: 0K
描述: IC SNGL-CHIP TXRX 32-TQFN
标准包装: 1
频率: 860 ~ 960MHz
数据传输率 - 最大: 200kbps
调制或协议: FSK,OOK
应用: AMR,ISM,安防门禁
功率 - 输出: 12.5dBm
灵敏度: -113dBm
电源电压: 2.1 V ~ 3.6 V
电流 - 接收: 3mA
电流 - 传输: 25mA
数据接口: PCB,表面贴装
天线连接器: PCB,表面贴装
工作温度: -40°C ~ 85°C
封装/外壳: 32-TQFN
包装: 标准包装
产品目录页面: 584 (CN2011-ZH PDF)
配用: 1210-1060-2-ND - 915MHZ ASPICS SX1211 CHIP SET
1210-1059-2-ND - 868MHZ ASPICS SX1211 CHIP SET
1210-1060-6-ND - 915MHZ ASPICS SX1211 CHIP SET
1210-1059-6-ND - 868MHZ ASPICS SX1211 CHIP SET
1210-1060-1-ND - 915MHZ ASPICS SX1211 CHIP SET
1210-1059-1-ND - 868MHZ ASPICS SX1211 CHIP SET
其它名称: SX1211I084DKR
SX1211
WIRELESS & SENSING
Note for mass production: The VCO capacitance is piece to piece dependant. As such, the optimization proposed
above should be verified on several prototypes, to ensure that the population is centered on 100 mV.
3.2.6. PLL Loop Filter
To adequately reject spurious components arising from the comparison frequency Fcomp, an external 2 nd order
loop filter is employed.
RL1
LF_M
CL2
CL1
LF_P
Figure 7: Loop Filter
Following the recommendations made in section 3.2.4, the loop filter proposed in the reference design’s bill of
material on section 7.5.3 should be used. The loop filter settings are frequency band independent and are hence
relevant to all implementations of the SX1211.
3.2.7. PLL Lock Detection Indicator
The SX1211 also features a PLL lock detect indicator. This is useful for optimizing power consumption, by adjusting
the synthesizer wake up time (TS_FS), since the PLL startup time is lower than specified under nominal conditions.
The lock status can be read on bit IRQParam_PLL_lock, and must be cleared by writing a “1” to this same register.
In addition, the lock status can be reflected in pin 23 PLL_LOCK, by setting the bit IRQParam_Enable_lock_detect.
3.2.8. Frequency Calculation
As shown in Figure 5 the PLL structure comprises three different dividers, R, P and S, which set the output
frequency through the LO. A second set of dividers is also available to allow rapid switching between a pair of
frequencies: R1/P1/S1 and R2/P2/S2. These six dividers are programmed by six bytes of the register MCParam
from addresses 6 to 11.
3.2.8.1. FSK Mode
The following formula gives the relationship between the local oscillator, and R, P and S values, when using FSK
modulation.
Frf , fsk =
9
8
Flo
Frf , fsk =
9 Fxtal
8 R + 1
[ 75 ( P + 1 ) + S ) ]
3.2.8.2. OOK Mode
Due to the manner in which the baseband OOK symbols are generated, the signal is always offset by the FSK
frequency deviation (Fdev - as programmed in MCParam_Freq_dev). Hence, the center of the transmitted OOK
signal is:
Rev 8 – February 2013
Page 16 of 92
www.semtech.com
相关PDF资料
PDF描述
12-900-LPI XFRMR PWR 115/230V 12.6VCT 900MA
10-1200-LPI XFRMR PWR 115/230V 10VCT 1.2A
MT-6-12 XFRMR 115V 5V 1.75A 6VA 3OUT
ATMEGA64RZAV-10MU MCU ATMEGA644/AT86RF230 44-QFN
ATMEGA128RFA1-ZU IC AVR MCU 2.4GHZ XCEIVER 64QFN
相关代理商/技术参数
参数描述
SX1211I084TRT 制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1
SX1211I084TRT-CUT 制造商:Semtech Corporation 功能描述:
SX1211I097.TRT 制造商:Semtech Corporation 功能描述:
SX1211MESH-868 制造商:Semtech Corporation 功能描述:10 MODULES MESH NETWORK
SX1211SK868 制造商:Semtech Corporation 功能描述:Full Evalulation Kit For Ultra-Low Power Integrated UHF Transceiver