参数资料
型号: SX1211I084TRT
厂商: Semtech
文件页数: 24/92页
文件大小: 0K
描述: IC SNGL-CHIP TXRX 32-TQFN
标准包装: 1
频率: 860 ~ 960MHz
数据传输率 - 最大: 200kbps
调制或协议: FSK,OOK
应用: AMR,ISM,安防门禁
功率 - 输出: 12.5dBm
灵敏度: -113dBm
电源电压: 2.1 V ~ 3.6 V
电流 - 接收: 3mA
电流 - 传输: 25mA
数据接口: PCB,表面贴装
天线连接器: PCB,表面贴装
工作温度: -40°C ~ 85°C
封装/外壳: 32-TQFN
包装: 标准包装
产品目录页面: 584 (CN2011-ZH PDF)
配用: 1210-1060-2-ND - 915MHZ ASPICS SX1211 CHIP SET
1210-1059-2-ND - 868MHZ ASPICS SX1211 CHIP SET
1210-1060-6-ND - 915MHZ ASPICS SX1211 CHIP SET
1210-1059-6-ND - 868MHZ ASPICS SX1211 CHIP SET
1210-1060-1-ND - 915MHZ ASPICS SX1211 CHIP SET
1210-1059-1-ND - 868MHZ ASPICS SX1211 CHIP SET
其它名称: SX1211I084DKR
SX1211
WIRELESS & SENSING
or to fill the FIFO buffers with glitch-free data in Buffered mode. The operation of the receiver is now described in
detail.
Note: Image rejection is achieved by the SAW filter.
3.4.2. LNA and First Mixer
In receive mode, the RFIO pin is connected to a fixed gain, common-gate, Low Noise Amplifier (LNA). The
performance of this amplifier is such that the Noise Figure (NF) of the receiver can be estimated to be ≈ 7 dB.
3.4.3. IF Gain and Second I/Q Mixer
Following the LNA and first down-conversion, there is an IF amplifier whose gain can be programmed from -
13.5 dB to 0 dB in 4.5 dB steps, via the register MCParam_IF_gain. The default setting corresponds to 0 dB gain,
but lower values can be used to increase the RSSI dynamic range. Refer to section 3.4.7 for additional information.
3.4.4. Channel Filters
The second mixer stages are followed by the channel select filters. The channel select filters have a strong
influence on the noise bandwidth and selectivity of the receiver and hence its sensitivity. Each filter comprises a
passive and active section.
3.4.4.1. Passive Filter
Each channel select filter features a passive second-order RC filter, with a bandwidth programmable through the
bits RXParam_PassiveFilt. As the wider of the two filters, its effect on the sensitivity is negligible, but its bandwidth
has to be setup instead to optimize blocking immunity. The value entered into this register sets the single side
bandwidth of this filter. For optimum performance it should be set to 3 to 4 times the cutoff frequency of the active
Butterworth (or polyphase) filter described in the next section.
3 * Fc ButterfFil t ≤ BW passive , filter ≤ 4 * Fc ButterFilt
3.4.4.2. Active Filter
The ’fine’ channel selection is performed by an active, third-order, Butterworth filter, which acts as a low-pass filter
for the zero-IF configuration (FSK), or a complex polyphase filter for the Low-IF (OOK) configuration. The
RXParam_PolypFilt_on bit enables/disables the polyphase filter.
Low-pass filter for FSK ( RXParam_PolyFilt_on=’’0’’)
-f C
0
f C
f requency
Polyphase filter for OOK ( RXParam_PolyFilt_on=’’1’’ )
Canceled side of
the polyphase filter
-f C
-f o
0
f requency
Figure 17: Active Channel Filter Description
Rev 8 – February 2013
Page 24 of 92
www.semtech.com
相关PDF资料
PDF描述
12-900-LPI XFRMR PWR 115/230V 12.6VCT 900MA
10-1200-LPI XFRMR PWR 115/230V 10VCT 1.2A
MT-6-12 XFRMR 115V 5V 1.75A 6VA 3OUT
ATMEGA64RZAV-10MU MCU ATMEGA644/AT86RF230 44-QFN
ATMEGA128RFA1-ZU IC AVR MCU 2.4GHZ XCEIVER 64QFN
相关代理商/技术参数
参数描述
SX1211I084TRT 制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1
SX1211I084TRT-CUT 制造商:Semtech Corporation 功能描述:
SX1211I097.TRT 制造商:Semtech Corporation 功能描述:
SX1211MESH-868 制造商:Semtech Corporation 功能描述:10 MODULES MESH NETWORK
SX1211SK868 制造商:Semtech Corporation 功能描述:Full Evalulation Kit For Ultra-Low Power Integrated UHF Transceiver