- 您现在的位置：买卖IC网 > PDF目录18758 > SX1211I084TRT (Semtech)IC SNGL-CHIP TXRX 32-TQFN PDF资料下载
参数资料
| 型号： | SX1211I084TRT |
| 厂商： | Semtech |
| 文件页数： | 51/92页 |
| 文件大小： | 0K |
| 描述： | IC SNGL-CHIP TXRX 32-TQFN |
| 标准包装： | 1 |
| 频率： | 860 ~ 960MHz |
| 数据传输率 - 最大： | 200kbps |
| 调制或协议： | FSK，OOK |
| 应用： | AMR，ISM，安防门禁 |
| 功率 - 输出： | 12.5dBm |
| 灵敏度： | -113dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 3mA |
| 电流 - 传输： | 25mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-TQFN |
| 包装： | 标准包装 |
| 产品目录页面： | 584 (CN2011-ZH PDF) |
| 配用： | 1210-1060-2-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-2-ND - 868MHZ ASPICS SX1211 CHIP SET 1210-1060-6-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-6-ND - 868MHZ ASPICS SX1211 CHIP SET 1210-1060-1-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-1-ND - 868MHZ ASPICS SX1211 CHIP SET |
| 其它名称： | SX1211I084DKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页当前第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页
SX1211
WIRELESS & SENSING
Optional DC free data coding
CRC checksum calculation
Length
Preamble
1 to 4 bytes
Sync Word
1 to 4 bytes
Length
byte
Address
byte
Message
0 to (FIFO size - 1) bytes
CRC
2-bytes
Payload/FIFO
Fields added by the packet handler in Tx and processed and removed in Rx
Optional User provided fields which are part of the payload
Message part of the payload
Figure 44: Variable Length Packet Format
5.5.3. Tx Processing
In Tx mode the packet handler dynamically builds the packet by performing the following operations on the payload
available in the FIFO:
Add a programmable number of preamble bytes
Add a programmable Sync word
Optionally calculating CRC over complete payload field (optional length byte + optional address byte +
message) and appending the 2 bytes checksum.
Optional DC-free encoding of the data (Manchester or whitening).
Only the payload (including optional address and length fields) is to be provided by the user in the FIFO.
Assuming that the chip is already in Tx mode then, depending on IRQParam_Tx_start_irq_0 bit, packet
transmission (starting with programmed preamble) will start either after the first byte is written into the FIFO
(Tx_start_irq_0=1) or after the number of bytes written reaches the user defined threshold (Tx_start_irq_0=0). The
FIFO can also be fully or partially filled in Stby mode via PKTParam_Fifo_stby_access. In this case, the start
condition will only be checked when entering Tx mode.
At the end of the transmission (Tx_done = 1), the user must explicitly exit Tx mode if required. (e.g. back to Stby)
Note that while in Tx mode, before and after actual packet transmission (not enough bytes or Tx_done), additional
preamble bytes are automatically sent to the modulator. When the start condition is met, the current additional
preamble byte is completely sent before the transmission of the next packet (i.e. programmed preamble) is started.
5.5.4. Rx Processing
In Rx mode the packet handler extracts the user payload to the FIFO by performing the following operations:
Receiving the preamble and stripping it off.
Detecting the Sync word and stripping it off.
Optional DC-free decoding of data.
Optionally checking the address byte.
Optionally checking CRC and reflecting the result on CRC_status bit and CRC_OK IRQ source.
Only the payload (including optional address and length fields) is made available in the FIFO.
Payload_ready and CRC_OK interrupts (the latter only if CRC is enabled) can be generated to indicate the end of
the packet reception.
Rev 8 – February 2013
Page 51 of 92
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| 12-900-LPI | XFRMR PWR 115/230V 12.6VCT 900MA |
| 10-1200-LPI | XFRMR PWR 115/230V 10VCT 1.2A |
| MT-6-12 | XFRMR 115V 5V 1.75A 6VA 3OUT |
| ATMEGA64RZAV-10MU | MCU ATMEGA644/AT86RF230 44-QFN |
| ATMEGA128RFA1-ZU | IC AVR MCU 2.4GHZ XCEIVER 64QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SX1211I084TRT | 制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1 |
| SX1211I084TRT-CUT | 制造商:Semtech Corporation 功能描述: |
| SX1211I097.TRT | 制造商:Semtech Corporation 功能描述: |
| SX1211MESH-868 | 制造商:Semtech Corporation 功能描述:10 MODULES MESH NETWORK |
| SX1211SK868 | 制造商:Semtech Corporation 功能描述:Full Evalulation Kit For Ultra-Low Power Integrated UHF Transceiver |
发布紧急采购，3分钟左右您将得到回复。