- 您现在的位置：买卖IC网 > PDF目录18758 > SX1211I084TRT (Semtech)IC SNGL-CHIP TXRX 32-TQFN PDF资料下载
参数资料
| 型号： | SX1211I084TRT |
| 厂商： | Semtech |
| 文件页数： | 57/92页 |
| 文件大小： | 0K |
| 描述： | IC SNGL-CHIP TXRX 32-TQFN |
| 标准包装： | 1 |
| 频率： | 860 ~ 960MHz |
| 数据传输率 - 最大： | 200kbps |
| 调制或协议： | FSK，OOK |
| 应用： | AMR，ISM，安防门禁 |
| 功率 - 输出： | 12.5dBm |
| 灵敏度： | -113dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 3mA |
| 电流 - 传输： | 25mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-TQFN |
| 包装： | 标准包装 |
| 产品目录页面： | 584 (CN2011-ZH PDF) |
| 配用： | 1210-1060-2-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-2-ND - 868MHZ ASPICS SX1211 CHIP SET 1210-1060-6-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-6-ND - 868MHZ ASPICS SX1211 CHIP SET 1210-1060-1-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-1-ND - 868MHZ ASPICS SX1211 CHIP SET |
| 其它名称： | SX1211I084DKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页当前第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页
SX1211
WIRELESS & SENSING
FIFO are lost. On the other hand if Tx_start_irq_0 = 0 then the extra bytes are kept into the FIFO. This opens up
the possibility of transmitting more than one packet by filling the FIFO with multiple packet messages.
It is not possible to receive multiple packets. Once a packet has been received and filled into the FIFO all its
content needs to be read i.e. the FIFO must be empty for a new packet reception to be initiated.
The Payload_ready interrupt goes high when the last payload byte is available in the FIFO and remains high until
all its data are read. Similar behavior is applicable to Adrs_match and CRC_OK interrupts.
The CRC result is available in the CRC_status bit as soon as the CRC_successful and Payload_ready interrupt
sources are triggered. In Rx mode, CRC_status is cleared when the complete payload has been read from the
FIFO. If the payload is read in Stby mode, then CRC_status is cleared when the user goes back to Rx mode and a
new Sync word is detected.
The Fifo_fill_method and Fifo_fill bits don’t have any meaning in the Packet mode and should be set to their default
values only.
Rev 8 – February 2013
Page 57 of 92
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| 12-900-LPI | XFRMR PWR 115/230V 12.6VCT 900MA |
| 10-1200-LPI | XFRMR PWR 115/230V 10VCT 1.2A |
| MT-6-12 | XFRMR 115V 5V 1.75A 6VA 3OUT |
| ATMEGA64RZAV-10MU | MCU ATMEGA644/AT86RF230 44-QFN |
| ATMEGA128RFA1-ZU | IC AVR MCU 2.4GHZ XCEIVER 64QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SX1211I084TRT | 制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1 |
| SX1211I084TRT-CUT | 制造商:Semtech Corporation 功能描述: |
| SX1211I097.TRT | 制造商:Semtech Corporation 功能描述: |
| SX1211MESH-868 | 制造商:Semtech Corporation 功能描述:10 MODULES MESH NETWORK |
| SX1211SK868 | 制造商:Semtech Corporation 功能描述:Full Evalulation Kit For Ultra-Low Power Integrated UHF Transceiver |
发布紧急采购，3分钟左右您将得到回复。