- 您现在的位置：买卖IC网 > PDF目录18758 > SX1211I084TRT (Semtech)IC SNGL-CHIP TXRX 32-TQFN PDF资料下载
参数资料
| 型号： | SX1211I084TRT |
| 厂商： | Semtech |
| 文件页数： | 25/92页 |
| 文件大小： | 0K |
| 描述： | IC SNGL-CHIP TXRX 32-TQFN |
| 标准包装： | 1 |
| 频率： | 860 ~ 960MHz |
| 数据传输率 - 最大： | 200kbps |
| 调制或协议： | FSK，OOK |
| 应用： | AMR，ISM，安防门禁 |
| 功率 - 输出： | 12.5dBm |
| 灵敏度： | -113dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 3mA |
| 电流 - 传输： | 25mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-TQFN |
| 包装： | 标准包装 |
| 产品目录页面： | 584 (CN2011-ZH PDF) |
| 配用： | 1210-1060-2-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-2-ND - 868MHZ ASPICS SX1211 CHIP SET 1210-1060-6-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-6-ND - 868MHZ ASPICS SX1211 CHIP SET 1210-1060-1-ND - 915MHZ ASPICS SX1211 CHIP SET 1210-1059-1-ND - 868MHZ ASPICS SX1211 CHIP SET |
| 其它名称： | SX1211I084DKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页
SX1211
WIRELESS & SENSING
As can be seen from Figure 17, the required bandwidth of this filter varies between the two demodulation modes.
FSK mode: The 99% energy bandwidth of an FSK modulated signal is approximated to be:
BW 99 %, FSK = 2 * ? Fdev +
?
?
BR ?
2 ??
The bits RXParam_ButterFilt set fc, the cutoff frequency of the filter. As we are in a Zero-IF configuration, the FSK
lobes are centered around the virtual “DC” frequency. The choice of fc should be such that the modulated signal
falls in the filter bandwidth, anticipating the Local Oscillator frequency drift over the operating temperature and
aging of the device:
2 * fc > BW 99 %, FSK + LO drifts
Please refer to the charts in section 3.4.5 for an accurate overview of the filter bandwidth vs. setting.
OOK mode: The 99% energy bandwidth of an OOK modulated signal is approximated to be:
BW 99 %, OOK =
2
Tbit
= 2 . BR
The bits RXParam_PolypFilt_center set fo, the center frequency of the polyphase filter when activated. fo should
always be chosen to be equal to the low Intermediate Frequency of the receiver (IF2). This is why, in the GUI
described in section 7.2.1 of this document, the low IF frequency of the OOK receiver denoted IF2 has been
replaced by fo.
The following setting is recommended:
fo = 100 kHz
RXParam _ PolypFilt = " 0011 "
The value stored in RXParam_ButterFilt determines fc, the filter cut-off frequency. So the user should set fc
according to:
2 * ( fc ? fo ) > BW 99 %, OOK + LO drifts
Again, fc as a function of RXParam_ButterFilt is given in the section 3.4.6.
3.4.5. Channel Filters Setting in FSK Mode
Fc, the 3dB cutoff frequency of the Butterworth filter used in FSK reception, is programmed through the bit
RXParam_ButterFilt. However, the whole receiver chain influences this cutoff frequency. Thus the channel select
and resultant filter bandwidths are summarized in the following chart:
Rev 8 – February 2013
Page 25 of 92
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| 12-900-LPI | XFRMR PWR 115/230V 12.6VCT 900MA |
| 10-1200-LPI | XFRMR PWR 115/230V 10VCT 1.2A |
| MT-6-12 | XFRMR 115V 5V 1.75A 6VA 3OUT |
| ATMEGA64RZAV-10MU | MCU ATMEGA644/AT86RF230 44-QFN |
| ATMEGA128RFA1-ZU | IC AVR MCU 2.4GHZ XCEIVER 64QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SX1211I084TRT | 制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1 |
| SX1211I084TRT-CUT | 制造商:Semtech Corporation 功能描述: |
| SX1211I097.TRT | 制造商:Semtech Corporation 功能描述: |
| SX1211MESH-868 | 制造商:Semtech Corporation 功能描述:10 MODULES MESH NETWORK |
| SX1211SK868 | 制造商:Semtech Corporation 功能描述:Full Evalulation Kit For Ultra-Low Power Integrated UHF Transceiver |
发布紧急采购，3分钟左右您将得到回复。