- 您现在的位置：买卖IC网 > PDF目录18751 > TRC103 (RFM)RFIC TRANSCEIVER MULTI-CHANNEL F PDF资料下载
参数资料
| 型号： | TRC103 |
| 厂商： | RFM |
| 文件页数： | 10/65页 |
| 文件大小： | 0K |
| 描述： | RFIC TRANSCEIVER MULTI-CHANNEL F |
| 标准包装： | 1 |
| 系列： | TRC |
| 频率： | 863MHz ~ 960MHz |
| 数据传输率 - 最大： | 100kbps |
| 调制或协议： | FSK，OOK |
| 应用： | 通用 |
| 功率 - 输出： | 11dBm |
| 灵敏度： | -112dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 4mA |
| 电流 - 传输： | 30mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-QFN |
| 包装： | 标准包装 |
| 产品目录页面： | 583 (CN2011-ZH PDF) |
| 其它名称： | 583-1095-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页
2.5 Frequency Synthesizer
The Frequency Synthesizer generates the local oscillator (LO) signal for the receiver and transmitter sections.
The core of the synthesizer is implemented with an integer-N PLL architecture.
The frequency is set by three divider parameters R, P and S. R is the frequency divider ratio in the reference fre-
quency path. P and S set the frequency divider ratio in the feedback loop of the PLL. The frequency synthesizer
includes a crystal oscillator which provides the frequency reference for the PLL. The equations giving the rela-
tionships between the reference crystal frequency, the local oscillator frequency and RF carrier frequency are giv-
en below:
F LO = F XTAL *(75*(P + 1) + S)/(R + 1), with P and S in the range 0 to 255, S less than (P + 1), R in the
range 64 to 169, and F LO and F XTAL in MHz.
F RF = 1.125*F LO , where F RF and F LO are in MHz
F LO is the first local oscillator (VCO) frequency, F XTAL is the reference crystal frequency and F RF is the RF channel
frequency.
F LO is the frequency used for the first down-conversion of the receiver and the second up-conversion of the
transmitter. The intermediate frequency used for the second down-conversion of the receiver and the first up-
conversion of the transmitter is equal to 1/8 of F LO . As an example, with a crystal frequency of 12.8 MHz and an
RF frequency of 869 MHz, F LO is 772.4 MHz and the first IF of the receiver is 96.6 MHz.
There are two sets of divider ratio registers: SynthR1[7..0] , SynthP1[7..0] , SynthS1[7..0 ], and SynthR2[7..0] ,
SynthP2[7..0] , SynthS2[7..0] . The MCFG00_RF_Frequency[0] bit is used to select which set of registers to use
as the current frequency setting. For frequency hopping applications, this reduces the programming and synthe-
sizer settling time when changing frequencies. While the data is being transmitted, the next frequency is pro-
grammed and ready. When the current transaction is complete, the MCFG00_RF_Frequency[0] bit is comple-
mented and the frequency shifts to the next freq according to the contents of the divider ratio registers. This pro-
cess is repeated for each frequency hop.
2.6 PLL Loop Filter
The loop filter for the frequency synthesizer is shown in Figure 6.
PLL Loop Filter
PLL Loop Filter Components
Name
C8
C9
R1
Value
1000 pF
6800 pF
6.8 k ?
Tolerance
±10%
±10%
±5%
Table 4
Figure 6
Typical recommended component values for the frequency synthesizer loop filter are provided in Table 4 above.
The loop filter settings are not dependent on the frequency band, so they can be universally used on all designs.
PLL lock status can be provided on Pin 23 by setting the IRQCFG0E_PLL_LOCK_EN[0] bit to a 1 (default).
When the PLL is locked Pin 23 (PLL_LOCK) is high, and when the PLL is unlocked Pin 23 is low. The lock status
of the PLL can also be checked by reading the IRQCFG0E_PLL_LOCK_ST[1] bit. Note that this bit latches high
each time the PLL locks and must be reset by writing a 1 to it.
www.RFM.com E-mail: info@rfm.com
? 2009-2010 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 10 of 65
TRC103 - 11/29/12
相关PDF资料 |
PDF描述 |
|---|---|
| UPC8179TB-A | IC AMPLIFIER LOW CURRENT SOT363 |
| UPC8178TB-E3-A | IC AMPLIFIER LOW CURRENT SOT363 |
| DP-241-7-16 | XFRMR PWR 115/230V 16VCT 3.5A |
| UPC8178TB-A | IC AMPLIFIER LOW CURRENT SOT363 |
| UPC2771TB-A | MMIC AMP 3V 2.4GHZ SOT363 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TRC1036 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
| TRC104 | 功能描述:射频收发器 Transceiver 2.4 GHz Multi-channel GFSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| TRC1044 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
| TRC105 | 功能描述:射频收发器 Transceiver 300-510 MHz, Multi-chnl FSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| TRC1053 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
发布紧急采购，3分钟左右您将得到回复。