- 您现在的位置：买卖IC网 > PDF目录18751 > TRC103 (RFM)RFIC TRANSCEIVER MULTI-CHANNEL F PDF资料下载
参数资料
| 型号： | TRC103 |
| 厂商： | RFM |
| 文件页数： | 54/65页 |
| 文件大小： | 0K |
| 描述： | RFIC TRANSCEIVER MULTI-CHANNEL F |
| 标准包装： | 1 |
| 系列： | TRC |
| 频率： | 863MHz ~ 960MHz |
| 数据传输率 - 最大： | 100kbps |
| 调制或协议： | FSK，OOK |
| 应用： | 通用 |
| 功率 - 输出： | 11dBm |
| 灵敏度： | -112dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 4mA |
| 电流 - 传输： | 30mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-QFN |
| 包装： | 标准包装 |
| 产品目录页面： | 583 (CN2011-ZH PDF) |
| 其它名称： | 583-1095-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页当前第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页
Received bits are valid (clocked out) on Pin 20 on low-to-high clock transitions on Pin 22. The clock signal is con-
trolled by RXCFG12 bit 6. Setting this bit to 0 enables bit clocking and setting this bit to 1 disables bit clocking.
Clocking must be used for FSK transmissions. It is optional for OOK transmissions.
While clocking is optional for FSK and OOK reception, enabling clocking provides additional bit stream filtering
and regeneration, even if the clock signal is not used by the microcontroller. To effectively use the data and clock
recovery feature, data must be transmitted with a bit rate accuracy of better than ±2%, and a 1-0-1-0… training
preamble of at least 24 bits must be sent at the beginning of a transmission. When clocking is enabled, continu-
ous mode will optionally support the detection of a start-of-packet (start) pattern when receiving. The start pattern
must be generated by the host microcontroller when transmitting. Start pattern detection is enabled by setting
RXCFG12 bit 5 to 1. The length of the start pattern is set by RXCFG12 bits 4..3 as follows:
RXCFG12 bits 4..3
00
01
10
11
Pattern Length
8 bits
16 bits
24 bits
32 bits
Table 70
The number of allowed bit errors in the start pattern is configured by RXCFG12 bits 2..1 as follows:
RXCFG12 bits 2..1
00
01
10
11
Error Tolerance
none
1 bit
2 bits
3 bits
Table 71
For most applications, a start pattern length of 24 to 32 bits is recommended with the error tolerance set to none.
The start pattern is stored in registers SYNCFG16 through SYNCFG19 . Received bits flow through a shift register
for pattern comparison with the most significant bit of SYNCFG16 compared to the earliest received bit and the
least significant bit of the last register (selected by the pattern length) compared to the last received bit. Pattern
detection is usually output on IRQ0, as discussed below. Refer to Figure 9 for pattern detection output timing. A
well designed pattern should contain approximately the same number of 1 and 0 bits to achieve DC-balance, it
should include frequent bit transitions, and it should be a pattern that is unlikely to occur in the encoded data fol-
lowing it.
As shown in Figure 19, two interrupt (control) outputs, IRQ0 and IRQ1, are provided by the TRC103 to coordinate
data flow to and from the host microcontroller. In Continuous data mode, one of two signals can be mapped to
IRQ0. This mapping is configured in register IRQCFG0D . Bits 7..6 select the signal for IRQ0 in the receive mode.
The mapping options for Continuous data mode are summarized in Table 72, where X denotes a don’t care bit
value. Note that IRQ1 always outputs DCLK in Continuous data mode when clocking is enabled.
www.RFM.com E-mail: info@rfm.com
? 2009-2010 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 54 of 65
TRC103 - 11/29/12
相关PDF资料 |
PDF描述 |
|---|---|
| UPC8179TB-A | IC AMPLIFIER LOW CURRENT SOT363 |
| UPC8178TB-E3-A | IC AMPLIFIER LOW CURRENT SOT363 |
| DP-241-7-16 | XFRMR PWR 115/230V 16VCT 3.5A |
| UPC8178TB-A | IC AMPLIFIER LOW CURRENT SOT363 |
| UPC2771TB-A | MMIC AMP 3V 2.4GHZ SOT363 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TRC1036 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
| TRC104 | 功能描述:射频收发器 Transceiver 2.4 GHz Multi-channel GFSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| TRC1044 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
| TRC105 | 功能描述:射频收发器 Transceiver 300-510 MHz, Multi-chnl FSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| TRC1053 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
发布紧急采购，3分钟左右您将得到回复。