参数资料
型号: TRC103
厂商: RFM
文件页数: 59/65页
文件大小: 0K
描述: RFIC TRANSCEIVER MULTI-CHANNEL F
标准包装: 1
系列: TRC
频率: 863MHz ~ 960MHz
数据传输率 - 最大: 100kbps
调制或协议: FSK,OOK
应用: 通用
功率 - 输出: 11dBm
灵敏度: -112dBm
电源电压: 2.1 V ~ 3.6 V
电流 - 接收: 4mA
电流 - 传输: 30mA
数据接口: PCB,表面贴装
天线连接器: PCB,表面贴装
工作温度: -40°C ~ 85°C
封装/外壳: 32-QFN
包装: 标准包装
产品目录页面: 583 (CN2011-ZH PDF)
其它名称: 583-1095-6
MCFG05 bits 7..6 set the length of the FIFO as shown in Table 78. The length of the FIFO must be equal to or
greater than the packet payload length set in PKTCFG1C , as discussed below.
MCFG05 bits 7..6
00
01
10
11
FIFO Length
16 bytes
32 bytes
48 bytes
64 bytes
Table 78
The integer value of MCFG05 bits 5..0 + 1 sets the FIFO interrupt threshold. When receiving in Packet data
mode, FIFO_Int_Rx is triggered when the number of bytes in the FIFO is equal to or greater than the threshold.
FIFO_Int_Tx is triggered when the number of bytes in the FIFO is equal to or less than the threshold value. Two
additional interrupts, nFIFOEMPY and FIFOFULL provide signaling that a packet transmission is complete or a
full packet has been received respectively.
Packet data mode formats are discussed in Section 3.9. Packet data mode options are configured in registers
PKTCFG1C through PKTCFG1F. Setting PKTCFG1C bit 7 to 1 selects Manchester encoding/decoding. Man-
chester encoding provides excellent DC-balance and other characteristics that support robust communications,
but effectively doubles the number of bits needed to transmit the packet payload. Scrambling provides adequate
DC-balance in many applications without doubling the number of bits in the payload. It is not necessary to enable
both Manchester encoding and scrambling. PKTCFG1C bits 6..0 configure the payload size (not including the
preamble and start pattern) in fixed format and maximum allowed length byte value in variable length and extend-
ed variable length formats. In a variable length format, a received packet with a length byte value greater than the
maximum allowed is discarded. PKTCFG1D bits 7..0 hold the node address byte used to identify a specific radio
in a network.
PKTCFG1E bit 7 configures the basic packet format. Setting this bit to 0 selects the fixed-length format, and set-
ting this bit to 1 selects the variable length format. PKTCFG1E bits 6..5 set the preamble length:
PKTCFG1E bits 6..5
00
01
10
11
Preamble Length
1 byte
2 bytes
3 bytes
4 bytes
Table 79
For most applications a preamble length of three or four bytes is recommended. PKTCFG1E bit 4 controls DC-
balanced scrambling. Setting this bit to 1 enables scrambling. PKTCFG1E bit 3 controls CRC calculations. Setting
his bit to 1 enables CRC calculations. PKTCFG1E bits 2..1 configure node address filtering:
PKTCFG1E bits 2..1
00
01
10
11
Node Address Filtering
no filtering
only node address accepted
node address and 0x00 accepted
node address, 0x00 and 0xFF accepted
Table 80
www.RFM.com E-mail: info@rfm.com
? 2009-2010 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 59 of 65
TRC103 - 11/29/12
相关PDF资料
PDF描述
UPC8179TB-A IC AMPLIFIER LOW CURRENT SOT363
UPC8178TB-E3-A IC AMPLIFIER LOW CURRENT SOT363
DP-241-7-16 XFRMR PWR 115/230V 16VCT 3.5A
UPC8178TB-A IC AMPLIFIER LOW CURRENT SOT363
UPC2771TB-A MMIC AMP 3V 2.4GHZ SOT363
相关代理商/技术参数
参数描述
TRC1036 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules
TRC104 功能描述:射频收发器 Transceiver 2.4 GHz Multi-channel GFSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
TRC1044 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules
TRC105 功能描述:射频收发器 Transceiver 300-510 MHz, Multi-chnl FSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
TRC1053 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules