- 您现在的位置：买卖IC网 > PDF目录18751 > TRC103 (RFM)RFIC TRANSCEIVER MULTI-CHANNEL F PDF资料下载
参数资料
| 型号： | TRC103 |
| 厂商： | RFM |
| 文件页数： | 53/65页 |
| 文件大小： | 0K |
| 描述： | RFIC TRANSCEIVER MULTI-CHANNEL F |
| 标准包装： | 1 |
| 系列： | TRC |
| 频率： | 863MHz ~ 960MHz |
| 数据传输率 - 最大： | 100kbps |
| 调制或协议： | FSK，OOK |
| 应用： | 通用 |
| 功率 - 输出： | 11dBm |
| 灵敏度： | -112dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 4mA |
| 电流 - 传输： | 30mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-QFN |
| 包装： | 标准包装 |
| 产品目录页面： | 583 (CN2011-ZH PDF) |
| 其它名称： | 583-1095-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页当前第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页
programming task less time critical. The values of P, S and R for OOK receive operation on several common
frequencies are given in Table 68 for a 0.1 MHz F IF2 . Software for determining P, S and R values for any in-band
frequency is provided with the TRC103 development kit.
Configuration
MCFG00 bits 4..3
P
S
R
868.3 MHz
10
85
63
107
915.0 MHz
01
121
1
143
955.0 MHz
10
126
26
143
Table 68
The RF channel frequency for OOK transmit is:
F RXRF = (14.4*(75*(P + 1) + S)/(R + 1)) - F IF2 , with P, S in the range 0 to 255, R in the range of 64 to 169
Where F RXRF and the OOK 2 nd IF frequency F IF2 are in MHz, and P, S, and R are divider integers where S must be
less than (P+1), and R has a value in the range of 64 to 169. An F IF2 value of 0.1 MHz is normally used. The val-
ues of P, S and R for OOK transmit operation on several common frequencies are given in Table 69 for a 0.1
MHz F IF2 . Software for determining P, S and R values is provided with the TRC103 development kit.
Configuration
MCFG00 bits 4..3
P
S
R
868.3 MHz
10
85
63
107
915.0 MHz
01
121
1
143
955.0 MHz
10
126
26
143
Table 69
6.6 TRC103 Data Mode Selection and Configuration
The TRC103 supports three data modes: continuous, buffered and packet. Continuous data mode provides the
most formatting flexibility, but places the heaviest demand on host microcontroller resources and requires the
most custom firmware development. In contrast, the Packet data mode unloads the host processor and the appli-
cation firmware from handing tasks such as DC-balanced data encoding, packet frame assembly and disassem-
bly, error detection, packet filtering and FIFO buffering. The trade-off for Packet data mode is limited flexibility in
data formatting parameters such as packet frame design. Buffered data mode falls between packet and Continu-
ous data mode capabilities, providing FIFO buffering, but allowing considerable flexibility in the design of the
packet frame.
Packet data mode is generally preferred as it supports the fastest application development time and requires the
smallest and least expensive host microcontroller. Buffered data mode covers applications that require a specific
packet frame design to support features such as multi-hop routing. Continuous data mode is reserved for special-
ized requirements, such as compatibility with a legacy product.
MCFG01 bit 5 and bit 2 select the data mode. Setting bit 2 to 1 enables packet mode regardless of the state of bit
5. If bit 2 is set to 0, then buffered mode is selected if bit 5 is set to 1 and continuous mode is selected if bit 5 is
set to 0. The TRC103 configuration details for each data mode are discussed below.
6.6.1 Continuous Data Mode
In Continuous data mode operation, transmitted data streams are applied to DATA Pin 20, and received data
streams are output on Pin 20. IRQ1 Pin 22 is usually configured to supply a clock signal to the host micro-
controller to pace the transmitted and received data steams. The clock signal is generated at the configured bit
rate. When transmitting, bits are clocked into Pin 20 on the low-to-high clock transitions at Pin 22.
www.RFM.com E-mail: info@rfm.com
? 2009-2010 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 53 of 65
TRC103 - 11/29/12
相关PDF资料 |
PDF描述 |
|---|---|
| UPC8179TB-A | IC AMPLIFIER LOW CURRENT SOT363 |
| UPC8178TB-E3-A | IC AMPLIFIER LOW CURRENT SOT363 |
| DP-241-7-16 | XFRMR PWR 115/230V 16VCT 3.5A |
| UPC8178TB-A | IC AMPLIFIER LOW CURRENT SOT363 |
| UPC2771TB-A | MMIC AMP 3V 2.4GHZ SOT363 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TRC1036 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
| TRC104 | 功能描述:射频收发器 Transceiver 2.4 GHz Multi-channel GFSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| TRC1044 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
| TRC105 | 功能描述:射频收发器 Transceiver 300-510 MHz, Multi-chnl FSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| TRC1053 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules |
发布紧急采购，3分钟左右您将得到回复。