参数资料
型号: TRC103
厂商: RFM
文件页数: 14/65页
文件大小: 0K
描述: RFIC TRANSCEIVER MULTI-CHANNEL F
标准包装: 1
系列: TRC
频率: 863MHz ~ 960MHz
数据传输率 - 最大: 100kbps
调制或协议: FSK,OOK
应用: 通用
功率 - 输出: 11dBm
灵敏度: -112dBm
电源电压: 2.1 V ~ 3.6 V
电流 - 接收: 4mA
电流 - 传输: 30mA
数据接口: PCB,表面贴装
天线连接器: PCB,表面贴装
工作温度: -40°C ~ 85°C
封装/外壳: 32-QFN
包装: 标准包装
产品目录页面: 583 (CN2011-ZH PDF)
其它名称: 583-1095-6
Data and clock recovery is enabled by default. It is controlled by RXCFG12_DCLK_Dis[6] . If data and clock re-
covery is disabled, the output of the demodulator is directed to DATA and the DCLK output (IRQ1 Pin in continu-
ous mode) is set to 0.
The received bit rate is defined by the value of the MCFG03_Bit_Rate[6..0] configuration register, and is calcu-
lated as follows:
BR = F XTAL /(64*(D + 1)), with D in the range of 0 to 127
with BR the bit rate in kb/s, F XTAL the crystal frequency in kHz, and D the value in MCFG03_Bit_Rate[6..0] . For
example, using a 12.8 MHz crystal (12,800 kHz), the bit rate is 25 kb/s when D = 7.
3.3 Continuous Mode Start Pattern Recognition
Start pattern detection (recognition) is activated by setting the RXCFG12_Recog[5] bit to 1. The demodulated
signal is compared with a pattern stored in the SYNCFG registers. The Start Pattern Detect (PATTERN) signal,
mapped to output pin IRQ0, is driven by the output of this comparator and is synchronized by DCLK. It is set to 1
when a start pattern match is detected, otherwise it is set to 0. The Start Pattern Detect output is updated at the
rising edge of DCLK. The number of bytes used for comparison is defined in the RXCFG12_Pat_sz[4..3] register
and the number of tolerated bit errors for the pattern detection is defined in the RXCFG12_Ptol[2..1] register.
Figure 9 illustrates the pattern detection process.
S ta r t P a tte r n D e te c tio n T im in g
D A T A
B it 0
B it 1
B it N -1
B it N
B it N + 1
D C L K
P A T T E R N
D E T E C T
Figure 9
Note that start pattern detection is enabled only if data and clock recovery is enabled.
3.4 RSSI
The received signal strength is measured in the amplifier chains behind the second mixers. Each amplifier chain
is composed of 11 amplifiers each having a gain of 6 dB and an intermediate output at 3 dB. By monitoring the
two outputs of each stage, an estimation of the signal strength with a resolution of 3 dB and a dynamic range of
63 dB is obtained without IF gain compensation. This estimation is performed 16 times over a period of the I and
Q signals and the 16 samples are averaged to obtain a final RSSI value with a 0.5 dB step. The period of the I
and Q signal is the inverse of the deviation frequency, which is the low-IF frequency in OOK mode. The RSSI
effective dynamic range can be increased to 70 dB by adjusting MCFG01_IF_Gain[1..0] for less gain on high
signal levels.
www.RFM.com E-mail: info@rfm.com
? 2009-2010 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 14 of 65
TRC103 - 11/29/12
相关PDF资料
PDF描述
UPC8179TB-A IC AMPLIFIER LOW CURRENT SOT363
UPC8178TB-E3-A IC AMPLIFIER LOW CURRENT SOT363
DP-241-7-16 XFRMR PWR 115/230V 16VCT 3.5A
UPC8178TB-A IC AMPLIFIER LOW CURRENT SOT363
UPC2771TB-A MMIC AMP 3V 2.4GHZ SOT363
相关代理商/技术参数
参数描述
TRC1036 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules
TRC104 功能描述:射频收发器 Transceiver 2.4 GHz Multi-channel GFSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
TRC1044 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules
TRC105 功能描述:射频收发器 Transceiver 300-510 MHz, Multi-chnl FSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
TRC1053 制造商:未知厂家 制造商全称:未知厂家 功能描述:10/100M Single Port Transformer Modules