参数资料
型号: DSP56301VF100
厂商: Freescale Semiconductor
文件页数: 7/124页
文件大小: 0K
描述: IC DSP 24BIT FIXED-POINT 252-BGA
产品变化通告: DSP56301 Discontinuation 12/Nov/2009
标准包装: 60
系列: DSP563xx
类型: 定点
接口: 主机接口,SSI,SCI
时钟速率: 100MHz
非易失内存: ROM(9 kB)
芯片上RAM: 24kB
电压 - 输入/输出: 3.30V
电压 - 核心: 3.30V
工作温度: -40°C ~ 100°C
安装类型: 表面贴装
封装/外壳: 252-BGA
供应商设备封装: 252-MAPBGA(21x21)
包装: 托盘
DSP56301 Technical Data, Rev. 10
4-2
Freescale Semiconductor
Design Considerations
If the temperature of the package case (TT) is determined by a thermocouple, thermal resistance is
computed from the value obtained by the equation (TJ – TT)/PD.
As noted earlier, the junction-to-case thermal resistances quoted in this data sheet are determined using the first
definition. From a practical standpoint, that value is also suitable to determine the junction temperature from a case
thermocouple reading in forced convection environments. In natural convection, the use of the junction-to-case
thermal resistance to estimate junction temperature from a thermocouple reading on the case of the package will
yield an estimate of a junction temperature slightly higher than actual temperature. Hence, the new thermal metric,
thermal characterization parameter or
Ψ
JT, has been defined to be (TJ – TT)/PD. This value gives a better estimate
of the junction temperature in natural convection when the surface temperature of the package is used. Remember
that surface temperature readings of packages are subject to significant errors caused by inadequate attachment of
the sensor to the surface and to errors caused by heat loss to the sensor. The recommended technique is to attach a
40-gauge thermocouple wire and bead to the top center of the package with thermally conductive epoxy.
4.2 Electrical Design Considerations
Use the following list of recommendations to ensure correct DSP operation.
Provide a low-impedance path from the board power supply to each VCC pin on the DSP and from the
board ground to each GND pin.
Use at least six 0.01–0.1
μF bypass capacitors positioned as close as possible to the four sides of the
package to connect the VCC power source to GND.
Ensure that capacitor leads and associated printed circuit traces that connect to the chip VCC and GND pins
are less than 0.5 inch per capacitor lead.
Use at least a four-layer PCB with two inner layers for VCC and GND.
Because the DSP output signals have fast rise and fall times, PCB trace lengths should be minimal. This
recommendation particularly applies to the address and data buses as well as the IRQA, IRQB, IRQC, IRQD,
TA
, and BG pins. Maximum PCB trace lengths on the order of 6 inches are recommended.
Consider all device loads as well as parasitic capacitance due to PCB traces when you calculate
capacitance. This is especially critical in systems with higher capacitive loads that could create higher
transient currents in the VCC and GND circuits.
All inputs must be terminated (that is, not allowed to float) by CMOS levels except for the three pins with
internal pull-up resistors (TRST, TMS, DE).
Take special care to minimize noise levels on the VCCP, GNDP, and GNDP1 pins.
The following pins must be asserted after power-up: RESET and TRST.
CAUTION
This device contains protective circuitry to
guard against damage due to high static
voltage or electrical fields. However, normal
precautions are advised to avoid application
of any voltages higher than maximum rated
voltages
to
this
high-impedance
circuit.
Reliability of operation is enhanced if unused
inputs are tied to an appropriate logic voltage
level (for example, either GND or VCC).
相关PDF资料
PDF描述
DSP56303VL100B1 IC DSP 24BIT 100MHZ 196-BGA
DSP56311VF150B1 IC DSP 24BIT 150MHZ 196-BGA
DSP56321VF200R2 IC DSP 24BIT 200MHZ 196-BGA
DSP56852VFE IC DSP 16BIT 120MHZ 81-MAPBGA
DSP56854FGE IC DSP 16BIT 120MHZ 128-LQFP
相关代理商/技术参数
参数描述
DSP56301VF80 功能描述:数字信号处理器和控制器 - DSP, DSC MAP DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT
DSP56301VF80B1 功能描述:数字信号处理器和控制器 - DSP, DSC DSP56301VF80B1 RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT
DSP56301VL100 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:24-Bit Digital Signal Processor
DSP56301VL80 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:24-Bit Digital Signal Processor
DSP56302 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:DSP56301 Digital Signal Processor