- 您现在的位置：买卖IC网 > PDF目录69013 > M37274MA-XXXSP 8-BIT, MROM, MICROCONTROLLER, PDIP52 PDF资料下载
参数资料
| 型号： | M37274MA-XXXSP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, MROM, MICROCONTROLLER, PDIP52 |
| 封装： | 0.600 INCH, 1.778 MM PITCH, SHRINK, PLASTIC, DIP-52 |
| 文件页数： | 89/131页 |
| 文件大小： | 2049K |
| 代理商： | M37274MA-XXXSP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页当前第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页
60
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
M37274MA-XXXSP
PRELIMINARY
Notice:
This
is not
a final
specification.
Some
paramentic
limits
are
subject
to change.
MITSUBISHI MICROCOMPUTERS
(3) Dot Size
The dot size can be selected by a block unit. The dot size in vertical
direction is determined by dividing HSYNC in the vertical dot size con-
trol circuit. The dot size in horizontal is determined by dividing the
following clock in the horizontal dot size control circuit : the clock
gained by dividing the OSD clock source (data slicer clock, OSC1,
main clock) in the pre-divide circuit. The clock cycle divided in the
pre-divide circuit is defined as 1TC.
The dot size of the layer 1 is specified by bits 6 to 3 of the block
control register.
The dot size of the layer 2 is specified by the following bits : bits 3
and 4 of the block control register, bit 6 of the clock source control
register. Refer to Figure 56 (the structure of the block control regis-
ter), refer to Figure 65 (the structure of the clock source control reg-
ister).
The block diagram of dot size control circuit is shown in Figure 64.
Notes 1 : The pre-divide ratio = 3 cannot be used in the CC mode.
2 : The pre-divide ratio of the OSD mode block on the layer 2
must be same as that of the CC mode block on the layer 1
by bit 6 of the clock source control register.
3 : In the bi-scan mode, the dot size in the vertical direction is
2 times as compared with the normal mode. Refer to “(13)
Scan Mode” about the scan mode.
Fig. 64. Block Diagram of Dot Size Control Circuit
Fig. 65. Definition of Dot Sizes
HSYNC
Main clock
Synchronous
Cycle!2
circuit
Cycle!3
Pre-divide circuit
Clock cycle
= 1TC
Horizontal dot size
control circuit
Vertical dot size
control circuit
OSD control circuit
Data slicer
clock
(Note)
OSC1
Note: To use data slicer clock, set bit 0 of data slicer control register to “0.”
1 dot
Scanning line of F1(F2)
Scanning line of F2(F1)
1/2H
1H
2H
3H
3TC
2TC
1TC
相关PDF资料 |
PDF描述 |
|---|---|
| M37373M8-XXXSP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP52 |
| M37409M2-XXXFP | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP56 |
| M37413E6HXXXFP | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP80 |
| M37413M4-XXXFP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80 |
| M37420M4-XXXSP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP52 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M37276MF248SP | 制造商:MITSUBISHI 功能描述:* |
| M37276MF2575P | 制造商:MITSUBISHI 功能描述:* |
| M37276MF260SP | 制造商:MITSUBISHI 功能描述:* |
| M37276MF300SP | 制造商:MITSUBISHI 功能描述:* |
| M37276MF301SP | 制造商:MITSUBISHI 功能描述:* |
发布紧急采购，3分钟左右您将得到回复。