参数资料
型号: MT48V2M32LFFC
厂商: Micron Technology, Inc.
英文描述: 512K x 32 x 4 banks 2.5V SDRAM(2.5V,512K x 32 x 4组同步动态RAM)
中文描述: 为512k × 32 × 4银行2.5V的内存电压(2.5V,512K采样× 32 × 4组同步动态RAM)的
文件页数: 29/50页
文件大小: 1058K
代理商: MT48V2M32LFFC
29
64Mb: x32 SDRAM, 2.5V
BatRam_25V.p65 – Rev. 0.7, Pub. 2/01
Micron Technology, Inc., reserves the right to change products or specifications without notice.
2001, Micron Technology, Inc.
64Mb: x32, 2.5V
SDRAM
PRELIMINARY
NOTE (continued):
4. AUTO REFRESH, SELF REFRESH and LOAD MODE REGISTER commands may only be issued when all banks are idle.
5. A BURST TERMINATE command cannot be issued to another bank; it applies to the bank represented by the current state
only.
6. All states and sequences not shown are illegal or reserved.
7. READs or WRITEs to bank
m
listed in the Command (Action) column include READs or WRITEs with auto precharge
enabled and READs or WRITEs with auto precharge disabled.
8. CONCURRENT AUTO PRECHARGE: Bank
n
will initiate the auto precharge command when its burst has been interrupted
by bank
m
’s burst.
9. Burst in bank
n
continues as initiated.
10. For a READ without auto precharge interrupted by a READ (with or without auto precharge), the READ to bank
m
will
interrupt the READ on bank n, CAS latency later (Figure 7).
11. For a READ without auto precharge interrupted by a WRITE (with or without auto precharge), the WRITE to bank
m
will
interrupt the READ on bank
n
when registered (Figures 9 and 10). DQM should be used one clock prior to the WRITE
command to prevent bus contention.
12. For a WRITE without auto precharge interrupted by a READ (with or without auto precharge), the READ to bank
m
will
interrupt the WRITE on bank
n
when registered (Figure 17), with the data-out appearing CAS latency later. The last
valid WRITE to bank
n
will be data-in registered one clock prior to the READ to bank
m.
13. For a WRITE without auto precharge interrupted by a WRITE (with or without auto precharge), the WRITE to bank
m
will interrupt the WRITE on bank
n
when registered (Figure 15). The last valid WRITE to bank
n
will be data-in
registered one clock prior to the READ to bank
m.
14. For a READ with auto precharge interrupted by a READ (with or without auto precharge), the READ to bank
m
will
interrupt the READ on bank n, CAS latency later. The PRECHARGE to bank
n
will begin when the READ to bank
m
is
registered (Figure 24).
15. For a READ with auto precharge interrupted by a WRITE (with or without auto precharge), the WRITE to bank
m
will
interrupt the READ on bank
n
when registered. DQM should be used two clocks prior to the WRITE command to prevent
bus contention. The PRECHARGE to bank
n
will begin when the WRITE to bank
m
is registered (Figure 25).
16. For a WRITE with auto precharge interrupted by a READ (with or without auto precharge), the READ to bank
m
will
interrupt the WRITE on bank
n
when registered, with the data-out appearing CAS latency later. The PRECHARGE to bank
n
will begin after
t
WR is met, where
t
WR begins when the READ to bank
m
is registered. The last valid WRITE to bank
n
will be data-in registered one clock prior to the READ to bank
m
(Figure 26).
17. For a WRITE with auto precharge interrupted by a WRITE (with or without auto precharge), the WRITE to bank
m
will
interrupt the WRITE on bank
n
when registered. The PRECHARGE to bank
n
will begin after
t
WR is met, where
t
WR
begins when the WRITE to bank
m
is registered. The last valid WRITE to bank
n
will be data registered one clock prior
to the WRITE to bank
m
(Figure 27).
相关PDF资料
PDF描述
MT48V4M32LFFC SYNCHRONOUS DRAM
MT49H16M16 THERMISTOR PTC 100OHM 110DEG RAD
MT49H16M16FM REDUCED LATENCY DRAM RLDRAM
MT49H8M32 THERMISTOR PTC 100OHM 120DEG RAD
MT49H8M32FM REDUCED LATENCY DRAM RLDRAM
相关代理商/技术参数
参数描述
MT48V32M16S2FG-10 制造商:Micron Technology Inc 功能描述:32MX16 SSDRAM PLASTIC 2BOC 2.5V - Trays
MT48V32M16S2FG-8 ES 制造商:Micron Technology Inc 功能描述:DRAM CHIP MOBILE SDRAM 512MBIT 2.5V 54FBGA - Bulk