参数资料
型号: S29WS128J0PBFW002
厂商: SPANSION LLC
元件分类: PROM
英文描述: 8M X 16 FLASH 1.8V PROM, 55 ns, PBGA84
封装: 8 X 11.60 MM, LEAD FREE, FBGA-84
文件页数: 20/97页
文件大小: 2421K
代理商: S29WS128J0PBFW002
May 11, 2006 S29WS-J_00_A6
S29WS128J/064J
27
D a ta
Sh eet
Notes
1. The DYBs can be set (programmed to “0”) or cleared (erased to “1”) as often as needed.
When the parts are first shipped, the PPBs are cleared (erased to “1”) and upon power up or reset,
the DYBs can be set or cleared depending upon the ordering option chosen.
2. If the option to clear the DYBs after power up is chosen, (erased to “1”), then the sectorsmay
be modified depending upon the PPB state of that sector (see Table 7).
3. The sectors would be in the protected state If the option to set the DYBs after power up is
chosen (programmed to “0”).
4. It is possible to have sectors that are persistently locked with sectors that are left in the dy-
namic state.
5. The DYB Set or Clear commands for the dynamic sectors signify protected or unprotected
state of the sectors respectively. However, if there is a need to change the status of the per-
sistently locked sectors, a few more steps are required. First, the PPB Lock Bit must be
cleared by either putting the device through a power-cycle, or hardware reset. The PPBs can
then be changed to reflect the desired settings. Setting the PPB Lock Bit once again locks the
PPBs, and the device operates normally again.
6. To achieve the best protection, it is recommended to execute the PPB Lock Bit Set command
early in the boot code and protect the boot code by holding WP# = VIL. Note that the PPB
and DYB bits have the same function when ACC = VHH as they do when ACC =VIH.
Persistent Protection Bit Lock Bit
The Persistent Protection Bit Lock Bit is a global volatile bit for all sectors. When set (programmed
to “0”), it locks all PPBs and when cleared (programmed to “1”), allows the PPBs to be changed.
There is only one PPB Lock Bit per device.
Notes
1. No software command sequence unlocks this bit unless the device is in the password protec-
tion mode; only a hardware reset or a power-up clears this bit.
2. The PPB Lock Bit must be set (programmed to “0”) only after all PPBs are configured to the
desired settings.
Password Protection Method
The Password Protection Method allows an even higher level of security than the Persistent Sector
Protection Mode by requiring a 64 bit password for unlocking the device PPB Lock Bit. In addition
to this password requirement, after power up and reset, the PPB Lock Bit is set “0” to maintain
the password mode of operation. Successful execution of the Password Unlock command by en-
tering the entire password clears the PPB Lock Bit, allowing for sector PPBs modifications.
Notes
1. There is no special addressing order required for programming the password. Once the Pass-
word is written and verified, the Password Mode Locking Bit must be set in order to prevent
access.
2. The Password Program Command is only capable of programming “0”s. Programming a “1”
after a cell is programmed as a “0” results in a time-out with the cell as a “0”.
3. The password is all “1”s when shipped from the factory.
4. All 64-bit password combinations are valid as a password.
5. There is no means to verify what the password is after it is set.
6. The Password Mode Lock Bit, once set, prevents reading the 64-bit password on the data bus
and further password programming.
7. The Password Mode Lock Bit is not erasable.
8. The lower two address bits (A1–A0) are valid during the Password Read, Password Program,
and Password Unlock.
9. The exact password must be entered in order for the unlocking function to occur.
相关PDF资料
PDF描述
S29WS128J0PBAW002 8M X 16 FLASH 1.8V PROM, 55 ns, PBGA84
S2M 2 A, 1000 V, SILICON, RECTIFIER DIODE, DO-214AA
S2R72A44F12C4 UNIVERSAL SERIAL BUS CONTROLLER, PQFP48
S2V20-4000 1.7 A, 200 V, SILICON, RECTIFIER DIODE
S2V60-4070 1.7 A, SILICON, RECTIFIER DIODE
相关代理商/技术参数
参数描述
S29WS128J0PBFW01 制造商:SPANSION 制造商全称:SPANSION 功能描述:128/64 Megabit (8/4 M x 16-Bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst Mode Flash Memory
S29WS128J0PBFW10 制造商:SPANSION 制造商全称:SPANSION 功能描述:128/64 Megabit (8/4 M x 16-Bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst Mode Flash Memory
S29WS128J0PBFW11 制造商:SPANSION 制造商全称:SPANSION 功能描述:128/64 Megabit (8/4 M x 16-Bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst Mode Flash Memory
S29WS128N 制造商:SPANSION 制造商全称:SPANSION 功能描述:256/128/64 MEGABIT CMOS 1.8 VOLT ONLY SIMULTANEOUS READ/WRITE BURST MODE FLASH MEMORY
S29WS128N0LBAI010 制造商:SPANSION 制造商全称:SPANSION 功能描述:256/128/64 MEGABIT CMOS 1.8 VOLT ONLY SIMULTANEOUS READ/WRITE BURST MODE FLASH MEMORY