参数资料
型号: MRF89XAT-I/MQ
厂商: Microchip Technology
文件页数: 94/140页
文件大小: 0K
描述: RF ISM BAND TXRX 32 QFN
标准包装: 1
频率: 863MHz ~ 870MHz,902MHz ~ 928MHz,950MHz ~ 960MHz
数据传输率 - 最大: 200kbps
调制或协议: FSK,OOK
应用: ISM
功率 - 输出: 12.5dBm
灵敏度: -113dBm
电源电压: 2.1 V ~ 3.6 V
电流 - 接收: 3mA
电流 - 传输: 25mA
数据接口: PCB,表面贴装
存储容量: *
天线连接器: PCB,表面贴装
工作温度: -40°C ~ 85°C
封装/外壳: 32-WFQFN 裸露焊盘
包装: 标准包装
其它名称: MRF89XAT-I/MQDKR
MRF89XA
4.1
RF Transmitter Matching
4.3
SAW FILTER
The optimum load for the RF port at a given frequency
band is listed in Table 4-1 . These load values in the
table are expected by the RF port pins to have as an
antenna load for maximum power transfer. For all
FL1 is a SAW filter. While in Transmitting mode, the
SAW filter is used to suppress the harmonics. While in
Receiving mode, the SAW filter is used to reject the
image frequencies and out-of-band interfering signals.
antenna applications, an RF choke inductor (L2) must
be included during transmission because the RF out-
4.3.1
SAW FILTER PLOT
puts are of open-collector type.
Figure 4-2 and Figure 4-3 illustrates the plots of the
SAW filter used in the application circuit. The plots
4.2
Antenna Components
shown are representative. For exact specifications,
The MRF89XA is single-ended and has an unbalanced
input and output impedance close to 30-j25. Therefore,
it only requires a matching circuit to the SAW filter and
antenna. The C11, C12, and L6 are part of the match-
ing network these components make for the antenna
circuit. L1, C4, and C5 are tuned to provide that
impedance (30+j25) to the RFIO pin. In this case, the
transceiver will be able to transfer all power toward the
antenna. This impedance is called Optimum Load
Impedance. L2 is a RF choke inductor. L3 and L4 are
basically VCO inductors. The details are shown in
Figure 4-1 .
refer to the SAW Filter manufacturer data sheet.
TABLE 4-1:
ANTENNA LOAD VALUES
FOR 868 MHz AND 915 MHz
FREQUENCY BANDS
Band
FL1
C5
C4
L1
868 MHz TA0801A
915 MHz TA0281A
1.8 pF
1.8 pF
22 pF
30 pF
8.2 nH
10 nH
Note 1:
The SAW filter can be of EPCOS (B3717
and B3588) or Taisaw (TA0801A and
TA0281A) for 868 MHz and 915 MHz
respectively with matching components
remaining the same as shown in Figure 4-1
and Table 4-1 .
DS70622C-page 94
Preliminary
? 2010–2011 Microchip Technology Inc.
相关PDF资料
PDF描述
241-5-12L XFRMR PWR 115V 12.6VCT 1A LEADS
DPC-40-250 XFRMR PWR 115/230V 40VCT 250MA
ST-5-56 XFRMR PWR 115V 28V 440MA 12VA
6221 TIP STAIN-STEEL SHARP-PT .06"DMM
ST-5-48 XFRMR PWR 115V 24V 500MA 12VA
相关代理商/技术参数
参数描述
MRF8HP21080HR3 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780H-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21080HR5 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780H-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21080HSR3 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780S-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21080HSR5 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780S-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF8HP21130HR3 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 130W NI780-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray