- 您现在的位置：买卖IC网 > PDF目录20639 > ADE7878ACPZ (Analog Devices Inc)IC ENERGY METERING 3PH 40LFCSP PDF资料下载
参数资料
| 型号： | ADE7878ACPZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 36/100页 |
| 文件大小： | 0K |
| 描述： | IC ENERGY METERING 3PH 40LFCSP |
| 标准包装： | 1 |
| 输入阻抗： | 400 千欧 |
| 测量误差： | 0.2% |
| 电压 - 高输入/输出： | 2.4V |
| 电压 - 低输入/输出： | 0.4V |
| 电源电压： | 2.4 V ~ 3.7 V |
| 测量仪表类型： | 3 相 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 40-WFQFN 裸露焊盘，CSP |
| 供应商设备封装： | 40-LFCSP-WQ（6x6） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页
ADE7854/ADE7858/ADE7868/ADE7878
Data Sheet
PHASE A
VOLTAGE
PHASE A
CURRENT
LPF1 filter (see Figure 43), a settling time of 30 ms to 40 ms is
associated with this filter before the measurement is stable.
The period measurement has a resolution of 3.90625 μs/LSB
(256 kHz clock), which represents 0.0195% (50 Hz/256 kHz)
when the line frequency is 50 Hz and 0.0234% (60 Hz/256 kHz)
when the line frequency is 60 Hz. The value of the period register
ANGLE0
Figure 47. Delay Between Phase A Voltage and Phase A Current Is
Stored in the ANGLE0 Register
When the ANGLESEL[1:0] bits are set to 01, the delays between
phase voltages are measured. The delay between Phase A voltage
and Phase C voltage is stored into the ANGLE0 register. The
for 50 Hz networks is approximately 5120 (256 kHz/50 Hz) and
for 60 Hz networks is approximately 4267 (256 kHz/60 Hz). The
length of the register enables the measurement of line frequencies
as low as 3.9 Hz (256 kHz/2 16 ). The period register is stable at
±1 LSB when the line is established and the measurement does
not change.
[ sec ]
T L =
f L =
[ Hz ]
delay between Phase B voltage and Phase C voltage is stored in
the ANGLE1 register, and the delay between Phase A voltage
and Phase B voltage is stored in the ANGLE2 register (see
When the ANGLESEL[1:0] bits are set to 10, the delays between
phase currents are measured. Similar to delays between phase
voltages, the delay between Phase A and Phase C currents is stored
into the ANGLE0 register, the delay between Phase B and Phase C
The following expressions can be used to compute the line
period and frequency using the period register:
PERIOD[15:0] + 1
256 E 3
256 E 3
PERIOD[15: 0] + 1
Phase Voltage Sag Detection
(6)
(7)
currents is stored in the ANGLE1 register, and the delay between
Phase A and Phase B currents is stored into the ANGLE2
register (see Figure 48 for details).
The ADE7854 / ADE7858 / ADE7868 / ADE7878 can be pro-
grammed to detect when the absolute value of any phase voltage
drops below a certain peak value for a number of half-line cycles.
PHASE A
PHASE B
PHASE C
The phase where this event takes place is identified in Bits[14:12]
(VSPHASE[x]) of the PHSTATUS register. This condition is
PHASE B VOLTAGE
FULL SCALE
SAGLVL[23:0]
ANGLE2
ANGLE1
ANGLE0
Figure 48. Delays Between Phase Voltages (Currents)
The ANGLE0, ANGLE1, and ANGLE2 registers are 16-bit
unsigned registers with 1 LSB corresponding to 3.90625 μs
(256 kHz clock), which means a resolution of 0.0703° (360° ×
50 Hz/256 kHz) for 50 Hz systems and 0.0843° (360° × 60 Hz/
FULL SCALE
SAGLVL[23:0]
SAGCYC[7:0] = 0x4
PHASE A VOLTAGE
256 kHz) for 60 Hz systems. The delays between phase voltages
or phase currents are used to characterize how balanced the
load is. The delays between phase voltages and currents are
used to compute the power factor on each phase as shown in
the following Equation 5:
SAGCYC[7:0] = 0x4
BIT 16 (SAG) IN
STATUS1[31:0]
STATUS1[16] AND
PHSTATUS[12]
CANCELLED BY A
WRITE TO
STATUS1[31:0]
WITH SAG BIT SET
?
cos φ x = cos ? ANGLEx ×
? ?
where f LINE = 50 Hz or 60 Hz.
Period Measurement
360 ? × f LINE
256 kHz
?
?
? ?
(5)
IRQ1 PIN
VSPHASE[0] =
STATUS[16] AND
PHSTATUS[13]
SET TO 1
The ADE7854 / ADE7858 / ADE7868 / ADE7878 provide the
period measurement of the line in the voltage channel. Bits[1:0]
(PERSEL[1:0]) in the MMODE register select the phase voltage
used for this measurement. The period register is a 16-bit
unsigned register and updates every line period. Because of the
PHSTATUS[12]
VSPHASE[1] =
PHSTATUS[13]
Figure 49. SAG Detection
Rev. H | Page 36 of 100
相关PDF资料 |
PDF描述 |
|---|---|
| GBC06DREI-S13 | CONN EDGECARD 12POS .100 EXTEND |
| VI-J60-CX-F4 | CONVERTER MOD DC/DC 5V 75W |
| ECA10DCBT | CONN EDGECARD 20POS R/A .125 SLD |
| EL7242CSZ-T13 | IC DRIVER MOSFET DUAL HS 8-SOIC |
| ADE7169ASTZF16 | IC ENERGY METER 1PHASE 64LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADE7878ACPZ | 制造商:Analog Devices 功能描述:IC MULTIFUNCTION ENERGY METERING LFCSP40 |
| ADE7878ACPZ-RL | 功能描述:IC ENERGY METERING 3PH 40LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 能量测量 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:* |
| ADE7878XCPZ | 制造商:Analog Devices 功能描述:POLY PHASE MULTIFUNCTION ENERGY METERING IC WITH TOTAL - Bulk |
| ADE7880 | 制造商:Analog Devices 功能描述:BOARD EVAL ENERGY METER ADE |
| ADE7880ACPZ | 功能描述:IC ENERGY METERING 3PH 40LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 能量测量 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:* |
发布紧急采购，3分钟左右您将得到回复。