- 您现在的位置：买卖IC网 > PDF目录20639 > ADE7878ACPZ (Analog Devices Inc)IC ENERGY METERING 3PH 40LFCSP PDF资料下载
参数资料
| 型号： | ADE7878ACPZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 48/100页 |
| 文件大小： | 0K |
| 描述： | IC ENERGY METERING 3PH 40LFCSP |
| 标准包装： | 1 |
| 输入阻抗： | 400 千欧 |
| 测量误差： | 0.2% |
| 电压 - 高输入/输出： | 2.4V |
| 电压 - 低输入/输出： | 0.4V |
| 电源电压： | 2.4 V ~ 3.7 V |
| 测量仪表类型： | 3 相 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 40-WFQFN 裸露焊盘，CSP |
| 供应商设备封装： | 40-LFCSP-WQ（6x6） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页当前第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页
p(t)= V rms × I rms – V rms × I rms × cos(2ωt)
ADE7854/ADE7858/ADE7868/ADE7878
If the phase currents and voltages contain only the fundamental
component, are in phase (that is φ 1 = γ 1 = 0), and they correspond
to full-scale ADC inputs, then multiplying them results in an
instantaneous power signal that has a dc component, V 1 × I 1 ,
and a sinusoidal component, V 1 × I 1 cos(2ωt); Figure 65 shows
the corresponding waveforms.
INSTANTANEOUS
POWER SIGNAL
0x3FED4D6
67,032,278
INSTANTANEOUS
ACTIVE POWER
SIGNAL: V rms × I rms
V rms × I rms
0x1FF6A6B =
33,516,139
0x000 0000
Data Sheet
PMAX = 33,516,139; it is the instantaneous power computed
when the ADC inputs are at full scale and in phase.
The xWATT[23:0] waveform registers can be accessed using
section for more details.
Fundamental Active Power Calculation— ADE7878 Only
The ADE7878 computes the fundamental active power using
a proprietary algorithm that requires some initializations function
of the frequency of the network and its nominal voltage measured
in the voltage channel. Bit 14 (SELFREQ) in the COMPMODE
register must be set according to the frequency of the network in
which the ADE7878 is connected. If the network frequency is
50 Hz, clear this bit to 0 (the default value). If the network fre-
quency is 60 Hz, set this bit to 1. In addition, initialize the VLEVEL
24-bit signed register with a positive value based on the
V FS
i(t) = √ 2 × I rms × sin( ω t)
v(t) = √ 2 × V rms × sin( ω t)
following expression:
VLEVEL = × 491 , 520
V n
(21)
Figure 65. Active Power Calculation
Because LPF2 does not have an ideal brick wall frequency
response (see Figure 66), the active power signal has some
ripple due to the instantaneous power signal. This ripple is
sinusoidal and has a frequency equal to twice the line frequency.
Because the ripple is sinusoidal in nature, it is removed when
the active power signal is integrated over time to calculate the
energy.
0
–5
–10
where:
V FS is the rms value of the phase voltages when the ADC inputs
are at full scale.
V n is the rms nominal value of the phase voltage.
As stated in the Current Waveform Gain Registers section, the
serial ports of the ADE7878 work on 32-, 16-, or 8-bit words
and the DSP works on 28 bits. Similar to the registers presented
in Figure 35, the VLEVEL 24-bit signed register is accessed as a
32-bit register with four most significant bits padded with 0s
and sign extended to 28 bits.
power measurement.
Table 14. Settling Time for Fundamental Active Power
Input Signals
–15
63% Full Scale
375 ms
100% Full Scale
875 ms
–20
Active Power Gain Calibration
Note that the average active power result from the LPF2 output
–25
0.1
1
FREQUENCY (Hz)
3
10
in each phase can be scaled by ±100% by writing to the phase’s
watt gain 24-bit register (AWGAIN, BWGAIN, CWGAIN,
V k I
1
xWATT = ∑
2 4
Figure 66. Frequency Response of the LPF Used
to Filter Instantaneous Power in Each Phase
The ADE7854 / ADE7858 / ADE7868 / ADE7878 store the
instantaneous total phase active powers into the AWATT,
BWATT, and CWATT registers. Their expression is
∞
× k × cos( φ k – γ k ) × PMAX ×
k = 1 V FS I FS
(20)
AFWGAIN, BFWGAIN, or CFWGAIN). The xWGAIN
registers are placed in each phase of the total active power
datapath, and the xFWGAIN (available for the ADE7878 only)
registers are placed in each phase of the fundamental active
power datapath. The watt gain registers are twos complement,
signed registers and have a resolution of 2 ?23 /LSB. Equation 22
describes mathematically the function of the watt gain registers.
Average Power Data =
LPF 2 Output × ? 1 +
Watt Gain Re gister ?
where:
V FS , I FS are the rms values of the phase voltage and current when
the ADC inputs are at full scale.
?
?
2 23 ?
?
(22)
Rev. H | Page 48 of 100
相关PDF资料 |
PDF描述 |
|---|---|
| GBC06DREI-S13 | CONN EDGECARD 12POS .100 EXTEND |
| VI-J60-CX-F4 | CONVERTER MOD DC/DC 5V 75W |
| ECA10DCBT | CONN EDGECARD 20POS R/A .125 SLD |
| EL7242CSZ-T13 | IC DRIVER MOSFET DUAL HS 8-SOIC |
| ADE7169ASTZF16 | IC ENERGY METER 1PHASE 64LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADE7878ACPZ | 制造商:Analog Devices 功能描述:IC MULTIFUNCTION ENERGY METERING LFCSP40 |
| ADE7878ACPZ-RL | 功能描述:IC ENERGY METERING 3PH 40LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 能量测量 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:* |
| ADE7878XCPZ | 制造商:Analog Devices 功能描述:POLY PHASE MULTIFUNCTION ENERGY METERING IC WITH TOTAL - Bulk |
| ADE7880 | 制造商:Analog Devices 功能描述:BOARD EVAL ENERGY METER ADE |
| ADE7880ACPZ | 功能描述:IC ENERGY METERING 3PH 40LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 能量测量 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:* |
发布紧急采购，3分钟左右您将得到回复。