Electrical Specifications
R
Mobile Intel
Pentium III Processor-M Datasheet
27
3.5
Maximum Ratings
Table 8 contains the Mobile Intel Pentium III Processor-M stress ratings. Functional operation at the
absolute maximum and minimum is neither implied nor guaranteed. The processor should not receive a
clock while subjected to these conditions. Functional operating conditions are provided in the AC and
DC tables. Extended exposure to the maximum ratings may affect device reliability. Furthermore,
although the processor contains protective circuitry to resist damage from static electric discharge, one
should always take precautions to avoid high static voltages or electric fields.
Table 8. Mobile Intel Pentium III Processor-M Absolute Maximum Ratings
Symbol
Parameter
Min
Max
Unit
Notes
TStorage
Storage Temperature
–40
85
°C
Note 1
VCC(Abs)
Supply Voltage with respect to VSS
–0.5 1.75
V
VCCT
System Bus Buffer Voltage with respect to VSS
–0.3 1.75
V
VIN GTL
System Bus Buffer DC Input Voltage with respect to VSS
–0.3 1.75
V
Notes 2, 3
VIN125
1.25V Buffer DC Input Voltage with respect to VSS
–0.3 1.75
V
Note 4
VIN15
1.5V Buffer DC Input Voltage with respect to VSS
–0.3 2.0
V
Note 5
VIN18
1.8V Buffer DC Input Voltage with respect to VSS
–0.3 2.0
V
Note 6
VIN20
2.0V Buffer DC Input Voltage with respect to VSS
–0.3 2.4
V
Note 7
VIN25
2.5V Buffer DC Input Voltage with respect to VSS
–0.3 3.3
V
Note 9
VINVID
VID ball/pin DC Input Voltage with respect to VSS
—
3.465
V
Note 8
IVID
VID Current
-0.3 3.6
mA
Note 8
NOTES:
1.
The shipping container is only rated for 65°C.
2.
Parameter applies to the AGTL signal groups only. Compliance with both VIN GTL specifications is required.
3.
The voltage on the AGTL signals must never be below –0.3 or above 1.75 V with respect to ground.
4.
Parameter applies to CLKREF, GHI#, TESTHI, VTTPWRGD signals.
5.
Parameter applies to CMOS, Open-drain, APIC, TESTLO and TAP bus signal groups only.
6.
Parameter applies to PWRGOOD signal.
7.
Parameter applies to PICCLK signal.
8.
Parameter applies to each VID pin/ball individually.
9.
Parameter applies to BCLK signal in Single Ended Clocking Mode.
3.6
DC Specifications
Table 9 through Table 18 list the DC specifications for the Mobile Intel Pentium III Processor-M.
Specifications are valid only while meeting specifications for the junction temperature, clock
frequency, and input voltages. The junction temperature range for all DC specifications is 0°C to
100°C. Care should be taken to read all notes associated with each parameter. Unlike the Mobile
Pentium III Processor, the Vcc tolerances for the Mobile Intel Pentium III Processor-M are not specified
as a percentage of nominal. The tolerances are instead specified in the form of load lines for the static
and transient cases in Table 10 through Table 15. Illustration of the load lines is shown in Figure 4 and
Figure 5.