Electrical Specifications
R
Mobile Intel
Pentium III Processor-M Datasheet
29
Symbol
Parameter
Min
Typ
Max
Unit
Notes
0.95 V
1.05 V
1.10 V
1.15 V
1.40 V
1.88
3.36
3.09
4.52
8.85
Notes 4, 12
ICC,QS
Processor Quick Start current at
0.95 V
1.05 V
1.10 V
1.15 V
1.40 V
1.82
3.22
2.91
4.30
8.53
A
Note 4
Notes 4, 12
ICC,DSLP
Processor Deep Sleep Leakage current at
0.95 V
1.05 V
1.10 V
1.15 V
1.40 V
1.70
3.01
2.65
3.99
8.04
A
Note 4
Notes 4, 12
ICC,DPRSLP
Processor Deeper Sleep Leakage current
1.70
A
Note 5
ICC,DPRSLPULV
Processor Deeper Sleep Leakage current
1.27
A
Notes 5, 12
ILVID
VID leakage current
0.5
mA
Note 9
dICC/dt
VCC power supply current slew rate
400
A/
s Notes 6, 7
NOTES:
1.
Unless otherwise noted, all specifications in this table apply to all processor frequencies. Processors will comply
with the ICCx,max specification for the current mode of operation.
2.
Static voltage regulation includes: DC output initial voltage set point adjust, output ripple and noise, temperature
and warm up.
3.
ICCT is the current supply for the system bus buffers, including the on-die termination.
4.
ICCx,max specifications are specified at VCC static (typical) derived from the tolerances in Table 10 through Table
15, VCCT,max, Tjmax, and under maximum signal loading conditions.
5.
Maximum ICC,DPRSLP specified at VCC = 0.85 V.
6.
Based on simulations and averaged over the duration of any change in current. Use to compute the maximum
inductance and reaction time of the voltage regulator. This parameter is not tested.
7.
Maximum values specified by design/characterization at nominal VCC and VCCT.
8.
VCCx must be within this range under all operating conditions, including maximum current transients. VCCx must
return to within the static voltage specification, VCCx,DC, within 100 s after a transient event.
9.
VID leakage current is < 100
A for VID voltages under 3.0 V.
10. Typical VCC indicates the VID encoded voltage. Voltage supplied must conform to the load line specification
shown in Table 10 through Table 15.
11. Voltages are measured at the processor socket pin for the Micro-FCPGA part and at the package ball on the
Micro-FCBGA part.
12. This specification applies only to the Ultra Low Voltage Mobile Intel Pentium III Processor-M.