参数资料
型号: RJ80530LZ001512
厂商: INTEL CORP
元件分类: 微控制器/微处理器
英文描述: 32-BIT, 1000 MHz, MICROPROCESSOR, CPGA478
封装: MICRO, FCPGA-478
文件页数: 93/96页
文件大小: 2018K
代理商: RJ80530LZ001512
Appendix A. PLL RLC Filter Specification
R
Mobile Intel
Pentium III Processor-M Datasheet
93
Table 53. PLL Filter Resistor Recommendations
Resistor
Part Number
Value
Tolerance
Power
R1
Various
1
10%
1/16 W
To satisfy damping requirements, total series resistance in the filter (from VCCT to the top plate of the
capacitor) must be at least 0.35
. This resistor can be in the form of a discrete component, or routing,
or both. For example, if the picked inductor has minimum DCR of 0.25
, then a routing resistance of
at least 0.10
is required. Be careful not to exceed the maximum resistance rule (2 ). For example,
if using discrete R1, the maximum DCR of the L should be less than 2.0 - 1.1 = 0.9
, which precludes
using L2 and possibly L1.
Other routing requirements include:
The capacitor should be close to the PLL1 and PLL2 pins, with less than 0.1 per route (These
routes do not count towards the minimum damping resistance requirement).
The PLL2 route should be parallel and next to the PLL1 route (minimize loop area).
The inductor should be close to the capacitor; any routing resistance should be inserted between
VCCT and the inductor.
Any discrete resistor should be inserted between VCCT and the inductor.
A4.
Comments
A magnetically shielded inductor protects the circuit from picking up external flux noise. This
should provide better timing margins than with an unshielded inductor.
A discrete or routed resistor is required because the LC filter by nature has an under-damped
response, which can cause resonance at the LC pole. Noise amplification at this band, although
not in the PLL-sensitive spectrum, could cause a fatal headroom reduction for analog circuitry.
The resistor serves to dampen the response. Systems with tight space constraints should consider
a discrete resistor to provide the required damping resistance. Too large of a damping resistance
can cause a large IR drop, which means less analog headroom and lower frequency.
Ceramic capacitors have very high self-resonance frequencies, but they are not available in large
capacitance values. A high self-resonant frequency coupled with low ESL/ESR is crucial for
sufficient rejection in the PLL and high frequency band. The recommended tantalum capacitors
have acceptably low ESR and ESL.
The capacitor must be close to the PLL1 and PLL2 pins; otherwise the value of the low ESR
tantalum capacitor is wasted. Note the distance constraint should be translated from the 0.1-
requirement.
相关PDF资料
PDF描述
RH80530GZ012512 32-BIT, 1266 MHz, MICROPROCESSOR, CPGA478
RH80530NZ006256 32-BIT, 1133 MHz, MICROPROCESSOR, CPGA478
RJ80530VZ733256 32-BIT, 733 MHz, MICROPROCESSOR, PBGA479
RH80530NZ001256 32-BIT, 1000 MHz, MICROPROCESSOR, CPGA478
RJ80530VY700256 32-BIT, 700 MHz, MICROPROCESSOR, PBGA479
相关代理商/技术参数
参数描述
RJ80530LZ733512 制造商:Rochester Electronics LLC 功能描述:- Bulk
RJ80530LZ733512S L5QS 制造商:Intel 功能描述:MPU Pentium? III Processor 64-Bit 0.13um 733MHz 479-Pin uFCBGA
RJ80530LZ866512 制造商:Rochester Electronics LLC 功能描述:- Bulk
RJ80530LZ933512 制造商:Rochester Electronics LLC 功能描述:- Bulk
RJ80530LZ933512S L68W 制造商:Intel 功能描述:MPU Pentium? III Processor-M 64-Bit 0.13um 933MHz 479-Pin uFCBGA