参数资料
型号: TSB12LV26PZ
厂商: Texas Instruments, Inc.
英文描述: OHCI-Lynx PCI-BASED IEEE 1394 HOST CONTROLLER
中文描述: OHCI的山猫基于PCI的1394主控制器
文件页数: 102/106页
文件大小: 605K
代理商: TSB12LV26PZ
8
9
consecutive isochronous packets during a single isochronous period. Unless multispeed concatenation is
enabled, all packets transmitted during a single bus ownership must be of the same speed (since the speed
of the packet is set before the first packet). If multispeed concatenation is enabled (when the EMSC bit of
Phy register 5 is set), the TSB12LV32 must specify the speed code of the next concatenated packet on the
D terminals when it asserts hold on the CTL terminals at the end of a packet. The encoding for this speed
code is the same as the speed code that precedes received packet data as given in Table 8
11.
After sending the last packet for the current bus ownership, the TSB12LV32 releases the bus by asserting
Idle on the CTL terminals for two clock cycles. The Phy begins asserting Idle on the CTL terminals one clock
after sampling Idle from the link. Note that whenever the D and CTL terminals change direction between
the Phy and the TSB12LV32, there is an extra clock period allowed so that both sides of the interface can
operate on registered versions of the interface signals.
00
00
00
00
01
00
(f)
SPD
00
10
(g)
(e)
(d)
(c)
(b)
(a)
01
00
00
00
00
00
11
dn
d0
Link controls CTL and D
Phy CTL and D outputs are High Impedance
D0
D7
CTL0, CTL1
SYSCLK
NOTE: SPD = Speed code, see Table 8
11, d0
dn = Packet data
Figure 8
6. Normal Packet Transmission Timing
The sequence of events for a normal packet transmission is as follows:
Transmit operation initiated. The Phy asserts grant on the CTL lines followed by Idle to hand over
control of the interface to the link so that the link may transmit a packet. The Phy releases control
of the interface (i.e., it places its CTL and D outputs in a high-impedance state) following the idle
cycle.
Optional idle cycle. The link may assert at most one Idle cycle preceding assertion of either hold
or transmit. This idle cycle is optional; the link is not required to assert Idle preceding either hold
or transmit.
Optional hold cycles. The link may assert hold for up to 47 cycles preceding assertion of transmit.
These hold cycle(s) are optional; the link is not required to assert hold preceding transmit.
相关PDF资料
PDF描述
TSB14AA1 FPGA (Field-Programmable Gate Array)
TSB14AA1I FPGA (Field-Programmable Gate Array)
TSB14AA1T FPGA (Field-Programmable Gate Array)
TSB14C01MHV IC APEX 20KE FPGA 160K 484-FBGA
TSB14C01HV 5-V IEEE 1394-1995 BACKPLANE TRANSCEIVER/ARBITER
相关代理商/技术参数
参数描述
TSB12LV26PZT 功能描述:1394 接口集成电路 OHCI-Lynx PCI-Based Host Controller RoHS:否 制造商:Texas Instruments 类型:Link Layer Controller 工作电源电压: 封装 / 箱体:LQFP 封装:Tray
TSB12LV26PZTG4 功能描述:1394 接口集成电路 OHCI-Lynx PCI-Based IEEE1394 Host Cntrlr RoHS:否 制造商:Texas Instruments 类型:Link Layer Controller 工作电源电压: 封装 / 箱体:LQFP 封装:Tray
TSB12LV26TPZEP 功能描述:1394 接口集成电路 Mil Enh OHCI-Lynx IEEE 1394 Host Cntlr RoHS:否 制造商:Texas Instruments 类型:Link Layer Controller 工作电源电压: 封装 / 箱体:LQFP 封装:Tray
TSB12LV31 制造商:TI 制造商全称:Texas Instruments 功能描述:IEEE 1394-1995 TRIPLE-CABLE TRANSCEIVER/ARBITER
TSB12LV31PZ 制造商:TI 制造商全称:Texas Instruments 功能描述:IEEE 1394-1995 General-Purpose Link-Layer Controller