- 您现在的位置：买卖IC网 > PDF目录2012 > MC92603VF (Freescale Semiconductor)IC TXRX ETH QUAD GIG 256-MAPBGA PDF资料下载
参数资料
| 型号： | MC92603VF |
| 厂商： | Freescale Semiconductor |
| 文件页数： | 47/126页 |
| 文件大小： | 0K |
| 描述： | IC TXRX ETH QUAD GIG 256-MAPBGA |
| 标准包装： | 1 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 4/4 |
| 规程： | 千兆位以太网 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 256-LBGA |
| 供应商设备封装： | 256-MAPBGA |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页当前第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页
Transmitter
MC92603 Quad Gigabit Ethernet Transceiver Reference Manual, Rev. 1
Freescale Semiconductor
2-5
disparity is maintained, and the appropriate transmission characters are produced, maintaining DC balance
and sufficient transition density to allow reliable data recovery at the receiver. The 8B/10B encoder is
bypassed if TBIE is asserted high.
The transmitter data interface operates at high frequency (nominally 125 MHz). In order to ease
development of devices that interface with the Gigabit Ethernet transceiver, all transmitter data input
interfaces are source-synchronous. The data for each channel has its own dedicated clock input. This
allows the clock at the source of the data to be routed with the data ensuring matched delay and timing.
However, if per-channel clock sources are not available or deemed unnecessary, all channels may be
clocked by a common clock source. This is enabled by asserting XMIT_REF_A high. When
XMIT_REF_A is high, the XMIT_A_CLK becomes the interface clock for all active channels.
The configuration settings of the MC92603 affect the legal range of clock frequencies at which it may be
operated. Table 5-1 shows legal transmit interface clock frequencies for all modes of operation. All
transmit interface clock inputs, XMIT_x_CLK, and the PLL reference clock inputs, REF_CLK, must have
identical frequencies. The transmit data interface tolerates
±180° of transmit interface clock phase drift
relative to the PLL reference clock input.
2.3.1
Transmit Driver Operation
The transmit driver outputs the transmission characters serially across the link. Two bits per internal
transceiver clock, rx_clock, one each on the rising and falling clock edges, are transmitted differentially
from the XLINK_x_P/XLINK_x_N outputs. The internal rx_clock runs at 625 MHz for 1-Gbps
(1.25-Gbaud) operation and 312.5 MHz for 500-Mbps (625-Mbaud) operation.
The transmitter driver (high-speed serial link outputs) is a controlled impedance driver. The impedance of
the driver is programmable to 50 or 75
through the MEDIA configuration signal. The drive impedance
is 50
when MEDIA is low and 75 when high.
2.3.2
Repeater Mode Operation
Although repeater mode is primarily used for factory engineering, it may be used by the application as
described in Section 5.5, “Repeater Mode.” The repeater enable signal, REPE, should be configured low
during a normal transceiver operation.
2.4
Backplane Application Modes (COMPAT = Low)
When the configuration control signal, COMPAT, is low, the MC92603 is in the ‘backplane application
mode.’ In this application mode, the MC92603 transmitters accept either uncoded data, where the input
data is encoded internally by an 8B/10B encoder, or coded data, where the input data is pre-encoded and
the internal encoder is bypassed.
The interface for the backplane application mode is either 8 or 10 bits wide, or optionally 4 or 5 bits, as
shown in Table 2-2.
相关PDF资料 |
PDF描述 |
|---|---|
| MC92604VM | IC ETH TXRX DUAL GIG 196-MAPBGA |
| MC92604ZT | IC TXRX ETH DUAL GIG 196-MAPBGA |
| MCP2120T-I/SL | IC ENCODR/DECODR 2.5V IR 14-SOIC |
| MCP2122-E/P | IC ENCODER/DECODER IRDA 8-DIP |
| MCP2122T-E/SNG | IC ENCODER/DECODR INFRARED 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC92603VM | 功能描述:IC ETH TXRX QUAD GIG 256-MAPBGA RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
| MC92604VM | 功能描述:IC ETH TXRX DUAL GIG 196-MAPBGA RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
| MC92604ZT | 功能描述:IC TXRX ETH DUAL GIG 196-MAPBGA RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:25 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:4.5 V ~ 5.5 V 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 供应商设备封装:16-PDIP 包装:管件 |
| MC92610 | 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES |
| MC92610VF | 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES |
发布紧急采购，3分钟左右您将得到回复。