- 您现在的位置：买卖IC网 > Datasheet目录345 > MT48H32M16LFB4-75B IT:C (Micron Technology Inc)IC SDRAM 512MB 54VFBGA Datasheet资料下载
参数资料
| 型号： | MT48H32M16LFB4-75B IT:C |
| 厂商： | Micron Technology Inc |
| 文件页数： | 49/85页 |
| 文件大小： | 0K |
| 描述： | IC SDRAM 512MB 54VFBGA |
| 标准包装： | 1,000 |
| 格式 - 存储器： | RAM |
| 存储器类型： | 移动 SDRAM |
| 存储容量： | 512M（32Mx16） |
| 速度： | 133MHz |
| 接口： | 并联 |
| 电源电压： | 1.7 V ~ 1.95 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 54-VFBGA |
| 供应商设备封装： | 54-VFBGA（8x8） |
| 包装： | 散装 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页当前第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页
512Mb: 32 Meg x 16, 16 Meg x 32 Mobile SDRAM
READ Operation
Figure 18: Random READ Accesses
T0
T1
T2
T3
T4
T5
CLK
Command
Address
DQ
READ
Bank,
Col n
READ
Bank,
Col a
READ
Bank,
Col x
D OUT
n
READ
Bank,
Col m
D OUT
a
NOP
D OUT
x
NOP
D OUT
m
CL = 2
T0
T1
T2
T3
T4
T5
T6
CLK
Command
READ
READ
READ
READ
NOP
NOP
NOP
Address
Bank,
Col n
Bank,
Col a
Bank,
Col x
Bank,
Col m
DQ
D OUT
n
D OUT
a
D OUT
x
D OUT
m
CL = 3
Don’t Care
Note:
1. Each READ command can be issued to any bank. DQM is LOW.
Data from any READ burst can be truncated with a subsequent WRITE command, and
data from a fixed-length READ burst can be followed immediately by data from a
WRITE command (subject to bus turnaround limitations). The WRITE burst can be ini-
tiated on the clock edge immediately following the last (or last desired) data element
from the READ burst, provided that I/O contention can be avoided. In a given system
design, there is a possibility that the device driving the input data will go Low-Z before
the DQ go High-Z. In this case, at least a single-cycle delay should occur between the
last read data and the WRITE command.
The DQM input is used to avoid I/O contention, as shown in Figure 19 (page 50) and
Figure 20 (page 51). The DQM signal must be asserted (HIGH) at least two clocks prior
to the WRITE command (DQM latency is two clocks for output buffers) to suppress da-
ta-out from the READ. After the WRITE command is registered, the DQ will go to High-Z
(or remain High-Z), regardless of the state of the DQM signal, provided the DQM was
active on the clock just prior to the WRITE command that truncated the READ com-
mand. If not, the second WRITE will be an invalid WRITE. For example, if DQM was
LOW during T4, then the WRITEs at T5 and T7 would be valid, and the WRITE at T6
would be invalid.
PDF: 09005aef8459c827
512mb_mobile_sdram_y67m_at.pdf – Rev. B 3/11 EN
49
Micron Technology, Inc. reserves the right to change products or specifications without notice.
? 2011 Micron Technology, Inc. All rights reserved.
相关PDF资料 |
PDF描述 |
|---|---|
| MT48H8M16LFB4-75 IT:K TR | IC SDRAM 128MBIT 133MHZ 54VFBGA |
| MTC100-JA2-P34 | CONTACT INSERT PIN |
| MX841BE | IC CONVERTER WHITE LED 8-SOIC |
| MXHV9910BTR | IC LED DRIVER HIGH BRIGHT 8-SOIC |
| MXN12FB12F | MOTOR BRUSHED DC 12V 2922RPM |
相关代理商/技术参数 |
参数描述 |
|---|
发布紧急采购，3分钟左右您将得到回复。