参数资料
型号: IPR-SDRAM/DDR2
厂商: Altera
文件页数: 38/106页
文件大小: 0K
描述: IP DDR2 SDRAM CONTROLLER RENEW
标准包装: 1
系列: *
类型: MegaCore
功能: DDR2 SDRAM 控制器
许可证: 续用许可证
3–2
Table 3–1 shows the standard SDRAM bus commands.
Table 3–1. Bus Commands
Chapter 3: Functional Description
Block Description
Command
No operation
Active
Read
Write
Burst terminate
Precharge
Auto refresh
Load mode register
Acronym
NOP
ACT
RD
WR
BT
PCH
ARF
LMR
ras_n
High
Low
High
High
High
Low
Low
Low
cas_n
High
High
Low
Low
High
High
Low
Low
we_n
High
High
High
Low
Low
Low
High
Low
The DDR and DDR2 SDRAM controllers must open SDRAM banks before they access
addresses in that bank. The row and bank to be opened are registered at the same time
as the active (ACT) command. The DDR and DDR2 SDRAM controllers close the bank
and open it again if they need to access a different row. The precharge (PCH)
command closes a bank.
The primary commands used to access SDRAM are read (RD) and write (WR). When
the WR command is issued, the initial column address and data word is registered.
When a RD command is issued, the initial address is registered. The initial data
appears on the data bus 2 to 3 clock cycles later (3 to 5 for DDR2 SDRAM). This delay
is the column address strobe (CAS) latency and is due to the time required to read the
internal DRAM core and register the data on the bus. The CAS latency depends on the
speed of the SDRAM and the frequency of the memory clock. In general, the faster the
clock, the more cycles of CAS latency are required. After the initial RD or WR
command, sequential reads and writes continue until the burst length is reached or a
burst terminate (BT) command is issued. DDR and DDR2 SDRAM devices support
burst lengths of 2, 4, or 8 data cycles. The auto-refresh command (ARF) is issued
periodically to ensure data retention. This function is performed by the DDR or DDR2
SDRAM controller.
The load mode register command (LMR) configures the SDRAM mode register. This
register stores the CAS latency, burst length, and burst type.
f
For more information, refer to the specification of the SDRAM that you are using.
Datapath
The datapath provides the interface between the read and write data busses of the
local interface and the double-clocked, bidirectional data bus of the memory. The
local data busses are twice the width of the memory data bus width, because the DDR
or DDR2 SDRAM data interface transfers data on both the rising and falling edges of
the clock.
? March 2009 Altera Corporation
相关PDF资料
PDF描述
GEM31DTBN-S189 CONN EDGECARD 62POS R/A .156 SLD
GEM31DTBH-S189 CONN EDGECARD 62POS R/A .156 SLD
GEM31DTBD-S189 CONN EDGECARD 62POS R/A .156 SLD
GEM31DTAN-S189 CONN EDGECARD 62POS R/A .156 SLD
10YXJ2200M10X20 CAP ALUM 2200UF 10V 20% RADIAL
相关代理商/技术参数
参数描述
IP-RSENC 功能描述:开发软件 Reed-Solomon Encoder MegaCore RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
IPR-SLITE2 功能描述:开发软件 SerialLite II MegaCore RENEWAL RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
IPR-SRAM/QDRII 功能描述:开发软件 QDRII SRAM Control MegaCore RENEWAL RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
IPR-SSIP 功能描述:开发软件 Crypto Bundle BU Solution RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
IPR-TRIETHERNET 功能描述:开发软件 Triple Speed Ethernt MegaCore RENEWAL RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors