参数资料
型号: IPR-SDRAM/DDR2
厂商: Altera
文件页数: 57/106页
文件大小: 0K
描述: IP DDR2 SDRAM CONTROLLER RENEW
标准包装: 1
系列: *
类型: MegaCore
功能: DDR2 SDRAM 控制器
许可证: 续用许可证
Chapter 3: Functional Description
3–21
Interfaces & Signals
1. The user logic requests the first write, by asserting the local_write_req signal,
and the size and address for this write. In this example, the request is a burst of
length 1 (2 on the DDR SDRAM side) to chip select 1. The local_ready signal is
asserted, which indicates that the controller has accepted this request, and the user
logic can request another read or write in the following clock cycle. If the
local_ready signal was not asserted, the user logic must keep the write request,
size, and address signals asserted.
2. The user logic requests a second write to a sequential address, this time of size 2 (4
on the DDR SDRAM side). The local_ready signal remains asserted, which
indicates that the controller has accepted the request.
3. The controller requests the write data and byte enables for the first write from the
user logic. The write data and byte enables must be presented in the clock cycle
after the request. In this example, the controller also continues to request write
data for the subsequent writes. The user logic must be able to supply the write
data for the entire burst when it requests a write.
4. The user logic requests the third write to a different chip select. The controller is
able to buffer up to four requests so the local_ready signal stays high and the
request is accepted.
5. When it has issued the necessary bank activation command, the controller issues
the first two write requests sequentially to the memory device.
6. Even though no data is being written to memory, the ddr_dqs signal must
continue toggling for the entire length of the memory device's burst length (8 in
this example).
For the Avalon-MM interface you should present the address ( local_addr ), the
write data ( local_wdtata ), and the write request ( local_write_req ) signal to
the controller with reference to the memory clock ( clk_to_sdram ). The Avalon-MM
interface does not use local_wdata_req .
Reads
Figure 3–14 on page 3–22 shows three read requests of different sizes. The controller
allows you to use any burst length up to the maximum burst length set on the
memory device. For example, if you select burst length of 8 for your DDR SDRAM
memory, the controller allows bursts of length 1, 2, 3, and 4 (2, 4, 6, and 8 on the DDR
SDRAM side).
1
The concept is similar for DDR2 SDRAM although only burst lengths 1 and 2 (2 and 4
on the DDR2 SDRAM side) are available.
? March 2009
Altera Corporation
相关PDF资料
PDF描述
GEM31DTBN-S189 CONN EDGECARD 62POS R/A .156 SLD
GEM31DTBH-S189 CONN EDGECARD 62POS R/A .156 SLD
GEM31DTBD-S189 CONN EDGECARD 62POS R/A .156 SLD
GEM31DTAN-S189 CONN EDGECARD 62POS R/A .156 SLD
10YXJ2200M10X20 CAP ALUM 2200UF 10V 20% RADIAL
相关代理商/技术参数
参数描述
IP-RSENC 功能描述:开发软件 Reed-Solomon Encoder MegaCore RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
IPR-SLITE2 功能描述:开发软件 SerialLite II MegaCore RENEWAL RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
IPR-SRAM/QDRII 功能描述:开发软件 QDRII SRAM Control MegaCore RENEWAL RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
IPR-SSIP 功能描述:开发软件 Crypto Bundle BU Solution RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
IPR-TRIETHERNET 功能描述:开发软件 Triple Speed Ethernt MegaCore RENEWAL RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors